Motor won't run continually
05-29-2003, 01:05 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2002
Location: Auburn,
AL
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Motor won't run continually
I just got an Astro 05 Brushless Motor and Jeti Speed controller with BEC. When I connect it to the receiver, I get 2 beeps from the Controller (one low and one high). When I move my throttle stick forward, the motor spins up and immediately stops. If I move the throttle stick extremely slow, I may get the motor to spin for about 2 seconds. Any ideas?
05-29-2003, 01:42 PM
#2
Motor won't run continually
Sounds to me like the battery doesn't have enough charge and the bec is taking the motor off line. They take it off at a certain voltage so you don't totally loose the battery and can keep control. Charge the battery up and try it again if you haven't.
05-29-2003, 02:17 PM
#3
Junior Member
Thread Starter
Join Date: Nov 2002
Location: Auburn,
AL
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Thanks!
I'll try that. I guess my battery could have been run down from all the previous trial and errors.
Any further Comments are suggestions are welcomed at the Airplanes --> Beginngers Forum
This Post is closed!!!
Any further Comments are suggestions are welcomed at the Airplanes --> Beginngers Forum
This Post is closed!!!
