RD6000 super
 

I have just received a RD6000 super and have a very basic question. When I go to AR1 THEN STW then down 1-- I get TRM instead of MLS-- WHATS up???? I don't see anything in the manual to explian it!! this is a new in the box -ebay item from a good seller but I think someone entered a program I can't get out of. Hope some you'll take the time to help me out. I used the end button to clear the program.

I am going to need some help here! I'm not real stupid---- just old with a rather flat learning curve.

Rone

Done the best I could

RE: RD6000 super
 

I think you're looking at the menu for elevator... try this...
1. Turn on transmitter.
2. Push "End" twice. Display should show "AR1" and a voltage reading.
3. Push "CH+" seven times. The display in the "CH" box should read "etc".
4. Push down arrow once... you should be at "MSL"

Hope this helps.

thanx ch140
 

It took two twice to see what I was looking at. I thought the large letters would change. WOW! THANK YOU for opening my eyes. Most people around here seem to use hitec and I was feeling a little lost.

Rone


done the best I could