RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   RC Radios, Transmitters, Receivers, Servos, gyros (https://www.rcuniverse.com/forum/rc-radios-transmitters-receivers-servos-gyros-157/)
-   -   New Radio and Digital Servos...need help (https://www.rcuniverse.com/forum/rc-radios-transmitters-receivers-servos-gyros-157/1639452-new-radio-digital-servos-need-help.html)

Qqu 03-19-2004 03:35 AM

New Radio and Digital Servos...need help
 
I just purchased a new Futaba 9zaps radio system with the R309DPS receiver. I am using some Hitec HG-5645MG Digital Servos. My problem is that a couple of these servos whine at neutral even when the is no load on them ie: just sitting on the table with no control arms on them. Anyone come across this before and if so, is there a solution? Thanks

Aaron

BaronSchwab 03-19-2004 09:03 AM

RE: New Radio and Digital Servos...need help
 
What do they do??

MikeMayberry 03-19-2004 12:16 PM

RE: New Radio and Digital Servos...need help
 
That is normal for digital servos. It is due to high refresh rate.

Mike.

causeitflies 03-19-2004 12:27 PM

RE: New Radio and Digital Servos...need help
 
They're not whining, they're singing;)

Qqu 03-19-2004 01:38 PM

RE: New Radio and Digital Servos...need help
 
OK, thanks. They just didn't do that (sing [:-] ) with my Eclipse and 2 out of the 4 I am using do it. I just thought maybe those 2 servos were defective or the radio system needed to be deadened around the neutral point.


All times are GMT -8. The time now is 07:53 AM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.