Hitec 56xx servos
I have just returned from trying to fly an airplane equipped with Hitec 5625 servos.
I had to quit because one of the servos was acting up. It would stick in a position and refuse to move. This is an indication that the motor has a dead spot in it. One of the problems of a three pole motor. This is a replacement servo for one I previously had that did not work. I am begining to get a bit irritated with Hitec as I had this same problem with some of thier other servos. I can probably fix it but I had to drive 50 miles to the field to fly and I just had to give up and go home. Hitec should change thier motor supplier. I am going to change my servo supplier. |
RE: Hitec 56xx servos
Try some JR servo's cost a little more but well worth the money. I have never had one fail other than stripping the gears.
|
RE: Hitec 56xx servos
Do a search on your particlar brand and model of servo and see what the common problems are..
|
RE: Hitec 56xx servos
ORIGINAL: BobbyRichardson Try some JR servo's cost a little more but well worth the money. I have never had one fail other than stripping the gears. |
RE: Hitec 56xx servos
Well,it turns out there was NO PROBLEM with my servos.
It was the Y connector. I'm sorry Hitec |
All times are GMT -8. The time now is 04:20 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.