Receiver crystal
If you have a Airtronics radio and use a Hitec positive receiver, what crystal do you use in the receiver? A Hitec or an Airtronics? I am new so I hope this isn't a stupid question!!!!
|
RE: Receiver crystal
Use the hitec crystal with a hitec rec. only.
|
RE: Receiver crystal
Thanks Bodary!!
I appreciate it! Keep the snow up there! Rollie |
RE: Receiver crystal
Glad i could help.
|
RE: Receiver crystal
Just make sure you select -shift to operate the Hitec receiver
|
RE: Receiver crystal
The shift has to be the same for both Tx and Rx. As I recall, Airtronics is + shift, so the Rx must be too. It should be obvious that the crystals have to be the same frequency. What is even more obvious is that the crystal you plug in the Rx should fit and be compatible with it.
Tx crystal are another story. Generally you can't change them without re-tuning the unit. However, I believe you can change a Tx crystal in a Tx module as long as it's in the correct end of the frequency spectrum (hi or lo). Ciao, Eagle Al:) |
RE: Receiver crystal
No, you can NOT change the crystal in a module without retuning the module. You can change the module in a transmitter with another module.
Pete |
All times are GMT -8. The time now is 05:31 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.