Polk's Tracker III, Seeker II Receiver
HELP. Just received my new Polk's Tacker III. I went to install my Futba S3101 servos into the Seeker 8 receiver and the connectors do not fit. The instructions state that "ALL MANUFACTURES SERVOS WILL WORK WITH THE SEEKER II AND 6." Any ideas or is there something I don't understand?
Thanks |
RE: Polk's Tracker III, Seeker II Receiver
cut the tabs off
|
RE: Polk's Tracker III, Seeker II Receiver
Grind the tabs down with a Dremel drum sander.
Jackjet |
RE: Polk's Tracker III, Seeker II Receiver
All, thanks for the help. we're up and running.
|
RE: Polk's Tracker III, Seeker II Receiver
Actually you dont have to cut tabs .... however it is a very tight fit, Good and Bad i suppose.
Look at the slots closely and you will notice the extended slot to accept the tab on Futaba connectors. |
RE: Polk's Tracker III, Seeker II Receiver
All servos fit. You don't have to cut anything off.
|
All times are GMT -8. The time now is 06:22 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.