Split elevator-Prisim programming ????
 

I need to know how to use two servos for a split elevator setup. I am using a Prisim 7X radio. I wasnt able to get equal movement with a reverser. All the adjust ment does is move the centering point. My arms & horns are right. I went to puting one servo in #2=elev & the other in #6-Flap since this was the only elevator mix. I can get them moving Ok now, except that only one side responds to trim. Also, the mix only occurs when the flap switch is up. Any ideas.

Hitech prism problem
 

Are there any Hitech Prism experts out there?

Split elevator-Prisim programming ????
 

I use four Prism's and an Eclipse. To the best of my knowledge the Prism has no dual channel elevator capability. The preprogramed mixs are avaliable but no programable mixs.

John