Can the Channel 7 knob on 8uap be turned off?
Trying to set up my airplane using the mix to set dual elevator servos instead of a y-connector. I have channel 7 slaved to channel 2. Everything works except the knob still is active. I don't want to get my trim off by accident.
Thanks V-Snap |
Can the Channel 7 knob on 8uap be turned off?
Set up another mix of 7-7 and set it at -100%. Hope this helps!
|
Can the Channel 7 knob on 8uap be turned off?
Almost there. You need to set -100% 2 times. Once with CH7 knob to the right of center and once with it left of center.
CH7 CH7 (Make sure you see the tiny ON symbol) -100% -100% LINK OFF OFST 0 SW-X NULL (set whatever switch you want. NULL makes the mix independent of the switch position) |
Can the Channel 7 knob on 8uap be turned off?
Thanks guys that worked. As soon as I get the 8 figured out it will be time for a 9C...
V-Snap |
All times are GMT -8. The time now is 12:17 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.