redcat rs10
#1
Thread Starter
redcat rs10
Ive got an rs10 crawler and while its done just about everything ive made it do I think my esc is going out.... While turning it does this retarded start stall start stall start stall like, a new driver learning to drive a standard trans.
Ive whoever is kind enough to not see that this a redcat cralwer and not be like eh and scroll past(i know redcats not really a favorite but I like em ) if ur not familiar with it, it runs off 2 motors both located on the axles they are a 380can I THINK and I wanna say they r 70t brushed motors.
So I need an esc that will push 2 motors like this and be able to run on a 2s lipo..
All help and advice is as always GREATLY appreciated
They r 390 cans and 70t. God I fail so hard it would help if I new what I had in my own car I guess!
Ive whoever is kind enough to not see that this a redcat cralwer and not be like eh and scroll past(i know redcats not really a favorite but I like em ) if ur not familiar with it, it runs off 2 motors both located on the axles they are a 380can I THINK and I wanna say they r 70t brushed motors.
So I need an esc that will push 2 motors like this and be able to run on a 2s lipo..
All help and advice is as always GREATLY appreciated
They r 390 cans and 70t. God I fail so hard it would help if I new what I had in my own car I guess!
Last edited by zackS30; 01-20-2014 at 07:36 PM. Reason: corrected info given bcuz I fail, hard.
#2
My brother had the same kind of problem when he went 4WS. A BEC fixed him up. problem was that power was being spread to too many places. I don't know what all you are running but this may be something to look at.....
KID EVIL!
KID EVIL!
#6
Thread Starter
That can handle a 2s 5000mah lipo?
Do u know what motors it can handle?
Thank you.
I looked it up, it seems to be only 1 motor I need a dual motor esc.
Do u know what motors it can handle?
Thank you.
I looked it up, it seems to be only 1 motor I need a dual motor esc.
Last edited by zackS30; 01-26-2014 at 09:11 PM.
#7
Senior Member
Join Date: May 2008
Location: Northern Occupied Mexico,
CA
Posts: 998
Likes: 0
Received 0 Likes
on
0 Posts
It can handle 2s, the capacity is irreverent.
Handles 2 motors from 35-55 turns.
http://www.teamnovak.com/products/es...oster_crawler/
Ive been using one in my RS10 for a few years now.
Handles 2 motors from 35-55 turns.
http://www.teamnovak.com/products/es...oster_crawler/
Ive been using one in my RS10 for a few years now.
Last edited by 1320Fastback; 01-27-2014 at 05:45 PM.
#8
My Feedback: (1)
Join Date: Feb 2010
Location: Sacramento,
CA
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Any decent esc can handle 2s lipo, & run 2 motors. Do you want dig? Cuz if ya do, then you can use a single esc & an electronic dig, Or, a dual motor esc. But an fxr or sidewinder will do nicely for ya. Lets ya run 3s too, unlike the rooster. Not to mention, castle & tekins stuff seems to be superior to novak's. Especially these days.