Italian semovente 75/18 3d printed
#1

I move the thread here.
Printed in synterized nylon high quality (the printer cost about 180k euros!!!), metal chassis brass soldered , bearings on sprocket wheels, bushes on the suspensions group, two electric motors and 3 servo for the cannon movements.
tested with Ibu and elmod electronics….
All the hatches can be opened…
all the measures are taken from the real tank (stock in Italian museum).
if you have any questions or you are interested with this tank you can contact me.










Printed in synterized nylon high quality (the printer cost about 180k euros!!!), metal chassis brass soldered , bearings on sprocket wheels, bushes on the suspensions group, two electric motors and 3 servo for the cannon movements.
tested with Ibu and elmod electronics….
All the hatches can be opened…
all the measures are taken from the real tank (stock in Italian museum).
if you have any questions or you are interested with this tank you can contact me.










#2

while we are waiting for the Matilda Stefano aka Gulliver’s factory send me this pictures: the first is a detail of an order of 4 semovente…. The second is a new already started project!!!








The following 2 users liked this post by Tank79:
P.E.D. Marine (03-31-2023),
tankme (03-22-2023)
#10

We have found a lot of information by a museum and other people that are checking information about this semovente. We think that can be 98 % correct
Last edited by Tank79; 09-30-2023 at 10:22 PM.
#11
#12

The following users liked this post:
Pah co chu puk (10-16-2023)