Turret roller bearings
1 Attachment(s)
I never mentioned this in the Cromwell thread, and this mod isn't tank specific.
I used 6mm airsoft pellets for roller bearings on the Cromwell turret. Those that have the HL Leo might appreciate this mod. http://www.rcuniverse.com/forum/atta...mentid=2052208 |
Another winner Dan.
We only have biodegradeable here (although they really don't seem to breakdown), but stainless BBs should work as well. |
IF I had stainless steels ones that is what I would have used.
|
That's a great idea! I'll have to give it a try on my HL Leo as you suggest.
CJ |
That's a great idea. How did you secure them but still leave enough slack for them to spin? Looks like they're installed into the upper hull.
|
You need some really good high polished ones. Walmart crossmans are not.
|
I drilled through the hull. I then glued a backing behind the holes, and the drilled a smaller diameter than the 6mm pellets through that. The ball just sits in place.
After this picture was taken I end up doing the same thing on the topside, so when you turn it over they don't fall out. |
Sounds simple but effective. Cool!
|
All times are GMT -8. The time now is 05:23 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.