RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   RC Tanks (https://www.rcuniverse.com/forum/rc-tanks-369/)
-   -   Drilling for TBU LED on TAM Pershing (https://www.rcuniverse.com/forum/rc-tanks-369/5931627-drilling-tbu-led-tam-pershing.html)

dacostasr 06-01-2007 05:09 PM

Drilling for TBU LED on TAM Pershing
 
I had the LED mounted on the barrel....kind of looked like a search light. Now my question can I drill out the port to the right of the barrel and place it there...kind of like the tiger.

I was just about ready to drill...thought I'd better get help!!

THanks in advance

Dennis

ksoc 06-01-2007 06:16 PM

RE: Drilling for TBU LED on TAM Pershing
 
1 Attachment(s)
Dennis,

It can be done. It has been a while since I did mine. If I remember correctly, the Pershing wasn't too bad. It was the Sherman where I had to hack a lot out to make room, and add a brass tube to get the proper depth for the emitter. Attached is a line of of my tanks from a few years ago. You can see the stock Tiger on the left, my modified Pershing in the middle, and the Sherman with the brass tube on the right. I will keep digging and see if I can come up with any picts of the inside.

dacostasr 06-01-2007 06:46 PM

RE: Drilling for TBU LED on TAM Pershing
 
Kevin,

Thanks I appreciate the help. You guys have a great webpage by the way!

Thanks again

Dennis


All times are GMT -8. The time now is 01:46 PM.


Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.