Pipe for a Novarossi N528XR
#1
Member
Thread Starter
Join Date: Nov 2007
Location: Colorado Springs,
CO
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Pipe for a Novarossi N528XR
I've just got a Mugen MBX5T and am putting a Novarossi N528XR in it. Anyone using this motor and if so what pipe are you using?
Thanks
Thanks
#2
Senior Member
RE: Pipe for a Novarossi N528XR
Mine was a PIA, but it DID have power. I ran an 086, which gave it a nice top end, but personally kind of liked it better with the JP-2 - made it easier to tune and gave it a big whopping mid-range...
I think both are good for that engine. 086 probably for a bit more speed..
I think both are good for that engine. 086 probably for a bit more speed..
#3
Member
Thread Starter
Join Date: Nov 2007
Location: Colorado Springs,
CO
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
RE: Pipe for a Novarossi N528XR
Thanks for the feedback ... I had heard a few people using the JP-2 ... last I looked, I think Tower Hobb** only sell the JP-4 and JP-6 ... not sure of the difference.