8ight t 2.0 rtr safety
 

i have recently converted my 8ight t 2.0 rtr to a brushless, 1717 castle, and a v3 esc. when i had the nitor engine on it i had the safety feature binded into it where if it lost connection with radio the brakes would be applied full, well this is still on with the brushless conversion, so one time i made the mistake of turning off my remote and my truck that was sitting on on top of my jacket took off rapping my jacket in the wheels( thank god) since it didnt get to run up my gfs leg that was standing beside it. my question is do i need to unbind and then rebind the receiver ? and how do i unbind the receiver also?

RE: 8ight t 2.0 rtr safety
 

There is no un-binding. Just follow the procedure to re-bind and make sure you're holding full brakes when you do so. You may wanna try binding with the throttle in the neutral position instead. That might work better for the ESC.

RE: 8ight t 2.0 rtr safety
 

neutral is the only way to do it, it cant realize i want it to break upon signal loss so it goes straight to forward, since i reversed the trigger on my remote