Hpi trophy truggy 4.6 help please
Hey everyone,
New to the forum from the UK, Oxford. Just after some help. I've purchased a hpi trophy truggy 4.6 with no engine or exhaust, manifold, clutch etc. I'm abit confused what the etc is haha. I have purchased a picco .28 engine which I'm hoping will fit...... Also the engine was on a losi 8 so hopefully the bell and clutch will work OK. What bits will I need to successfully complete the swap as I'm abit confused at the moment. I am a engineer so I'm sure I can handle the work. Any advice would be great on tuned exhaust and the manifold needed and other bits clutch, etc. Thanks Adam |
All times are GMT -8. The time now is 06:45 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.