New Hangar 9 P-51 60cc
07-12-2022, 10:22 AM
#1678
Originally Posted by Txmustangflyer
Bad Left main actuator. Waiting on them to come back in stock, so stalled until I can get a replacement.
07-13-2022, 12:52 PM
#1681
Performance unlimited "promod" Zenoah G62. It has benched with a 23x8 xoar scimitar at 7800 rpm. Also benched the ramoser at 6200 rpm 14 inches pitch, on the ground.
Estimated hp at 7800 7.2.
Estimated top speed..somewhere between 95 mph and 100 mph
Yes, it tucks in the cowl quite nicely. Picture taken before final trimming which was mainly to address possible cracking due to vibration and getting rif of the saw teeth.
Estimated hp at 7800 7.2.
Estimated top speed..somewhere between 95 mph and 100 mph
Yes, it tucks in the cowl quite nicely. Picture taken before final trimming which was mainly to address possible cracking due to vibration and getting rif of the saw teeth.
Last edited by Txmustangflyer; 07-13-2022 at 12:57 PM.
07-22-2022, 03:37 PM
#1682
Thread Starter
Hello,
That prop is pretty cool! What rpm are you getting at 8 or 10” of pitch? (If it can adjust that fine). 6200 sounds like quite a load. Have you installed baffles for cooling? We (My flying buddies) use dyrese foam. It cost less than $2 and adheres with ca like an sob. Very easy to work with. Also, did you do anything with a p-38? I ordered everything I can buy from ziroli. I’m curious if prekin can make better parts than the abs stuff, in particular, the turbos.
That prop is pretty cool! What rpm are you getting at 8 or 10” of pitch? (If it can adjust that fine). 6200 sounds like quite a load. Have you installed baffles for cooling? We (My flying buddies) use dyrese foam. It cost less than $2 and adheres with ca like an sob. Very easy to work with. Also, did you do anything with a p-38? I ordered everything I can buy from ziroli. I’m curious if prekin can make better parts than the abs stuff, in particular, the turbos.
