Go Back  RCU Forums > RCU Rules & FAQs > RCUniverse.com FAQ
Reload this Page >

Building a airsoft gun in wing of plane

Notices
RCUniverse.com FAQ RCU''s most frequently asked questions.

Building a airsoft gun in wing of plane

Old 08-23-2015, 08:47 PM
  #1  
rooster457e
Junior Member
Thread Starter
 
Join Date: Aug 2015
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Lightbulb Building a airsoft gun in wing of plane

Haven't found any good instructions for this other than, 7" aluminum brake line, air pressure and a holding tank.
the video I watched was a hand held model using a 20oz soda bottle with the brake line slid through a hole drilled in the cap with a little hot glue sealing it in.
the trigger was a blower nozzle drilled in to the side and center of the bottle.
the bottle then filled with roughly 150-200 BBs and then you had a fully auto gun as long as you were connected to the air compressor.
Has anyone done in a plane? I know I could use a small tank and run air lines through the wings but how well does it work? Where can I find anyone or anyone's previous plans and outcomes of this?
Ive decided it try a freon tank or co2 with single barrel brake line and will know in a week or so.
would love some input if anyone can help.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.