SH .18 Factory Needle Settings?
#2
Member
Join Date: Apr 2010
Location: Phoenix,
AZ
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
RE: SH .18 Factory Needle Settings?
Hello VS30,
Factory settings on the sh.18 engine are going to be 2.5-3 turns out from fully closed on the high and low speed needles. And the idle screw doesn't have a factory setting, just make sure the carb is open about 1mm.
Thanks,
Derek
RedcatRacing
Factory settings on the sh.18 engine are going to be 2.5-3 turns out from fully closed on the high and low speed needles. And the idle screw doesn't have a factory setting, just make sure the carb is open about 1mm.
Thanks,
Derek
RedcatRacing
#3
Join Date: Sep 2017
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
.18 nitro engine needle settings
[QUOTE=Redcat-Derek;9999326]Hello VS30,
Factory settings on the sh.18 engine are going to be 2.5-3 turns out from fully closed on the high and low speed needles. And the idle screw doesn't have a factory setting, just make sure the carb is open about 1mm.
Thanks,the high and low needle settings are not the same
Derek
RedcatRacing[/QUOTE
The high and low needle setting are not the same
Factory settings on the sh.18 engine are going to be 2.5-3 turns out from fully closed on the high and low speed needles. And the idle screw doesn't have a factory setting, just make sure the carb is open about 1mm.
Thanks,the high and low needle settings are not the same
Derek
RedcatRacing[/QUOTE
The high and low needle setting are not the same