caldera reverse problem
 

i have a problem, i have progtam the esc for voltage setting. After this program, reverse dont work. I have check on the esc the running mode and is ok. Do you have an idea?

RE: caldera reverse problem
 

did you program the esc via the radio...or with a program box?

RE: caldera reverse problem
 

direct on the esc

RE: caldera reverse problem
 

?
Not sure what you mean. But it sounds like you changed the driving mode when you tried to change the voltage setting.

Programing the ESC with a ezrun program card makes life 100 times easier.

1st, try recalibrating the ESC to the radio.

RE: caldera reverse problem
 

do you have a how to, for program to the radio?

RE: caldera reverse problem
 

[youtube]http://www.youtube.com/watch?v=_OkwkziFWE8[/youtube]

RE: caldera reverse problem
 

i have try, and they change anything.<div>
</div>

RE: caldera reverse problem
 

I believe that when you tried to change the voltage cutoff on the speed control, you accidently set it to "forward/brake" only setting.

It is pretty tricky to count all the "beeps" when setting the ESC with just the radio and button on the ESC. The Program card makes the chore a breeze.

If you have the program sheet for the ESC (can also be found online) follow the steps for changing the driving profile

RE: caldera reverse problem
 

i have check all setting and is at forward/brake/reverse ( 2 flash )