tunning engine
 

I had read somewhere here about engine tunning. The thing that im looking for is about if you pinch the fuel line and the engine revs a little bit (revs almost nothing)and then dies about 5 to 6 second lateris it lean or rich or the other way around if it revs alot for about 5 second and then dies(lean or rich). Im tunning a new engine the max temp that the engine gets its 210. sometimes if I give full speed it dies? rich or lean. It has a good smoke trail. I have driven it for 2 tanks for about 3 min. at a time and in idle its spits drops of fuel/oil but it doesnt smoke. good or bad. thanks for youre help. Oh bythe way the engine is a axe motor rossi speed

RE: tunning engine
 

Go here. Very good tunning guide:D[link]http://dads-toy.com/tuning.shtml[/link]

RE: tunning engine
 

hi,
im wondering if you guys could help me. i got a hurricane xp and i cant get it tuned right. no matter what i do it keeps overheating about 260-290 ive tried richening the fuel but it doesnt work.....i put about 6 tanks thought trying to tune it but no luck......can someone tell me what im doing wrong, it would be greatly apericiated.

RE: tunning engine
 

260s not bad i mean i usuall run mine between 250 -270 but the 290 a little high at least for my taste

RE: tunning engine
 

thats what imm thinking .....in the one case it got to 302 and i shut it down.....................this worries me that the temp will just keep climbing and burn up the motor. anyone have any sugestions?

RE: tunning engine
 

OK, I've seen in some of the other threads on here, That porting and changing pipe are both highly recommended to increase performance...I found an article on the Engine thread where they were talking about porting the sleeve, opening it up, notching the back of it, scooping the crank, skirting the piston, knife edging the con-rod and stuff like that. When I used to race 2 stroke dirt bikes, we used to do some of these and window the piston. However the posts were mostly talking about a kyosho ultima .12 and an OS .12. Can we do these things with our engines? Will they be of any benefit? I've got to tear mine down again to re-seal it and put a new carb on it anyway, I was thinking of trying this stuff out while I was at it...Any thoughts or comments? Here's a link to that thread...
http://www.rcuniverse.com/forum/m_26..._1/key_/tm.htm
Oh yeah, when I port and polish a car, we match the opening on the intake and header's with the ports on the head (or vice versa)...I know these work differently as the gasses don't pass through the head, but is it the same thing???

RE: tunning engine
 

The dads-toy link does not work. Can someone give some tuning instructions?

RE: tunning engine
 

Hope this helps a bit...

http://www.*********.org/cars_eng-tuning.htm

RE: tunning engine
 

I just wrote a post on this exact problem. It is for the vx 18. Not that there are any answers for the problem as of yet but there are ideas to check over. Its under the heading of vx.18 over heating problems!

RE: tunning engine
 

I kinda doubt that the guy back in september 2006 is even reading this post any more;)