RE: Electronics Problem
 

try setting your tuning needles up to their stock setting and try 2 1/2 on the high and flush with the low, make sure the carb is open a little like 1mm. try giving it a little throttle when your starting it

RE: Electronics Problem
 

I got it running and my new failsafe came. But the failsafe kicks on whenever i start to drive it? What it the problem and can i set it diffentley or something.

RE: Electronics Problem
 

most likely your batteries in the car are going dead. The failsafes kick in when the voltage drops below a certain point or the radio loses its signal. what failsafe do you have?

RE: Electronics Problem
 

I have a glow hobby failsafe the one you showed me on ebay. It goes onto the red light once u take off in it. but if it is sitting still and you gas it on a stand it won't.

RE: Electronics Problem
 

i really dont know, you may need to adjust it, see what the instructions say

RE: Electronics Problem
 

I had battery issues with mine and it was driving me nuts, when I connected my failsafe and started driving it would just engage the failsafe to full brake and start sounding the audible alert. Man I almost through that thing as far as I could but then I removed it and had similar issues with it steering on its own and acting weird, replaced batteries in the receiver box and all was fine.

RE: Electronics Problem
 

I got new batteries in the reciever everthing works great thanks MiniCwik.

RE: Electronics Problem
 

Do you know where i can get some pretty good tires for my tornado bb i have already worn the back tires down a lot because of donuts.