Drill Start
does anyone make a drillstart backplate for the redcat .16 engine
|
RE: Drill Start
the hpi nitrostar .15 will fit, its an exact fit, with the starter wand, it should run around $40
http://www2.towerhobbies.com/cgi-bin...?&I=LXFET0&P=7 |
RE: Drill Start
if u have a good drill, this is all you need.
http://www2.towerhobbies.com/cgi-bin...?&I=LXFET1&P=7 but think about it cause its kinda bulky, and you have to carry the drill and stuff around. i like that if my cars cut off all i need is the glow iginter, 1 or 2 yanks and im ready to go again. $0.02 |
All times are GMT -8. The time now is 11:34 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.