RCU Forums - process for changing servos

RCU Forums (https://www.rcuniverse.com/forum/)

- Redcat Racing Support (https://www.rcuniverse.com/forum/redcat-racing-support-427/)

- - process for changing servos (https://www.rcuniverse.com/forum/redcat-racing-support-427/6852635-process-changing-servos.html)

Swingline76

01-04-2008 12:24 PM

process for changing servos

is the process for changing servos as easy as it seems, meaning, all you have to do is take out old and put in new one. no programming of any sort involved when it comes to the servo?:eek: again i am very new at this and trying to learn as much as possible[:o][sm=confused.gif]

webdr

01-04-2008 12:31 PM

RE: process for changing servos

Nope, no programming, just take the old one out, install the new one WITH THE SERVO HORN NOT INSTALLED, plug it in and turn the transmitter/receiver on. Then center the trim on the transmitter and install the horn so its at 90 degrees (equal travel both directions)

Thats mainly for the steering servo, the throttle might be a little different, and its best to position the horn just like the old one.

All times are GMT -8. The time now is 05:44 PM.