Pull Start Installation??
 

I am getting ready to swap out the broken pull start on my Tornado BB and am curious the best way to do so. The inside 2 screws look impossible to get to. Does anyone have any tricks or should I just pull the engine??

RE: Pull Start Installation??
 

You have to pull the motor, no way around it sad to say.

RE: Pull Start Installation??
 

Not a problem, I just wanted to make sure before I went and pulled the engine.

RE: Pull Start Installation??
 

unfortunately you have to mesh the gears, which isnt a problem, but i dont like doing it as i sometimes wrongly mesh them. :(

RE: Pull Start Installation??
 

Does anyone know what pull start the newer VX-18's use?? Redcat has them with a 1" bolt pattern and 1 1/4" bolt patten.

RE: Pull Start Installation??
 

the newer ones are the 1" pattern

RE: Pull Start Installation??
 

I'm not too familiar with the bb I have a volcano, but if you can, I find it easier to just pull the whole rearend out as an assembly. You can then get to the inside screws much easier and don't have to mess with the mesh on the motor.

RE: Pull Start Installation??
 

just draw circles around the screws for the engine before u take it out so that u can line if up eaisly

RE: Pull Start Installation??
 

you might want to scribe the aluminum plate where the screws are. permanent marker sometimes gets worn off after running.