stalling problem
 

whenever i hit the brake in my volcano for more than a second it stalls at any speed making high speed driving impossible (to stop:D) any advice on tuning for this problem would help.

RE: stalling problem
 

maybe try raising your idle.

RE: stalling problem
 

Adjusting your Idle screw in maybe 1/4 turn should help your problem. What's happening is, when you hit the break it's closing the carb too much and not letting any air in the mix and it's stalling. I had this problem on my buggy yesterday so I adjusted my Idle screw and everything was good after that.

RE: stalling problem
 

If i turn up the idle any more it wont stay still at idle, but i'll mess around with it some more.

RE: stalling problem
 

your idle's good if it stays still, it's your low end needle, it's too rich