spadet lc 40 but make with epoxy
#1
Member
Thread Starter
Join Date: Jun 2003
Location: Kraljevica, CROATIA (HRVATSKA)
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
spadet lc 40 but make with epoxy
Please be so kind and inform me about:
weight of spadet is 5lb10oz. this weiht is with engine and electronics or ...?
my fuselage, wing, landing gear (made with epoxy) weight is 2kg. is this ok or to much ?
thanks
Realdo
weight of spadet is 5lb10oz. this weiht is with engine and electronics or ...?
my fuselage, wing, landing gear (made with epoxy) weight is 2kg. is this ok or to much ?
thanks
Realdo
#3
Member
Thread Starter
Join Date: Jun 2003
Location: Kraljevica, CROATIA (HRVATSKA)
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
RE: spadet lc 40 but make with epoxy
Ok, thanks Muldoer
I expect plane weight with engine tt46pro, electronics and other small parts not more than 3kg with 1650mm wingspan, 250mm chord flat bottom wing.
Thanks again
realdo
note: this is my first step in air r/c
I expect plane weight with engine tt46pro, electronics and other small parts not more than 3kg with 1650mm wingspan, 250mm chord flat bottom wing.
Thanks again
realdo
note: this is my first step in air r/c
#5
Senior Member
Join Date: Aug 2002
Location: Nacogdoches,
TX
Posts: 528
Likes: 0
Received 0 Likes
on
0 Posts
RE: spadet lc 40 but make with epoxy
Realdo,
Welcome to the wonderful world of SPAD RC airplanes! It is the most fun you will have with your shoes on!
Don't forget to take some pictures of your Spadet and post them!
Blue skies,
DL
Welcome to the wonderful world of SPAD RC airplanes! It is the most fun you will have with your shoes on!
Don't forget to take some pictures of your Spadet and post them!
Blue skies,
DL
#6
Senior Member
Join Date: Nov 2002
Location: RCHill,
NJ
Posts: 2,981
Likes: 0
Received 0 Likes
on
0 Posts
RE: spadet lc 40 but make with epoxy
SPAD planes are fun when they fly [:-] I have made three that only left the ground for a few seconds , but I have to admit the anticipation is what keeps me coming back for more.