Foamboard Tri Copter with EDF Vectored Thrust
09-10-2019, 07:53 PM
#1
Foamboard Tri Copter with EDF Vectored Thrust
Not built for accuracy but lots of fun… Some wobbles and jitters but gets the job done perfectly.
Ch5 high: pitch and roll differential thrust, yaw thrust vectoring
Ch5 mid: pitch, roll and yaw thrust vectoring, minimal tilt. MonoPhan thrust vectoring algotithm.
Ch5 low: pitch, roll and yaw thrust vectoring, optical flow position hold and BARO. No tilt… Arduino supported.
Fully foamboard with carbon fiber and aluminum enforcements.
Thanks!
https://www.youtube.com/watch?v=vxFPAqHvpYU
https://www.youtube.com/watch?v=vxFPAqHvpYU
Ch5 high: pitch and roll differential thrust, yaw thrust vectoring
Ch5 mid: pitch, roll and yaw thrust vectoring, minimal tilt. MonoPhan thrust vectoring algotithm.
Ch5 low: pitch, roll and yaw thrust vectoring, optical flow position hold and BARO. No tilt… Arduino supported.
Fully foamboard with carbon fiber and aluminum enforcements.
Thanks!
https://www.youtube.com/watch?v=vxFPAqHvpYU
https://www.youtube.com/watch?v=vxFPAqHvpYU
The following users liked this post:
jnayjaso (04-05-2020)
The following users liked this post:
jnayjaso (04-05-2020)
The following users liked this post:
jnayjaso (04-05-2020)
