Looking for 1/4 scale float hardware.
 

Can anyone tell me where to buy any hardware for usa 1/4 scale floats. pulleys etc. for retract water rudders and steering, have built some which are on the plane( cessna 182) but seem to be getting brittle and keep breaking. Any suggestions in this area would greatly be appreciated.

RE: Looking for 1/4 scale float hardware.
 

Not sure this is what your looking for. hope it helps.

I put this on my 1/4 scale Sig floats. (46"). I modified it w/ a servo on a tray inside.


http://www3.towerhobbies.com/cgi-bin...&I=LXE982&P=ML

RE: Looking for 1/4 scale float hardware.
 

You can get pulleys from Proctor

RE: Looking for 1/4 scale float hardware.
 

Tower has proctor pulleys.
http://www3.towerhobbies.com/cgi-bin...ARCH=PULLEY+++

If you want to save approximately the gross national product of Uganda, I just use 2-56 eyebolts. They work just like the guides on a fishing rod. Not as scale, but they work as well(maybe better) Also from tower:http://www3.towerhobbies.com/cgi-bin...=RF&search3=Go

RE: Looking for 1/4 scale float hardware.
 

go too [link]http://seacommander.com[/link]awesome floats i have a set on my top flight cessna 182 81 '' wing

RE: Looking for 1/4 scale float hardware.
 

Have a pair of 47" float cores that need a better home than my basement.....PM me.

FA[8D]