RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Redcat James
Showing results 1 to 25 of 77
Search took 0.07 seconds.
Forum: Redcat Racing Support
09-09-2014, 07:51 AM
Replies: 2
Views: 1,433
Posted By Redcat James

You can find all you engine hop ups here...

You can find all you engine hop ups here http://www.davesmotors.com/
I would recommend the pipe, clutch springs and maybe the coil.
Forum: Redcat Racing Support
09-08-2014, 11:39 AM
Replies: 4
Views: 585
Posted By Redcat James

02051t is for the aluminum suspension mounts.

02051t is for the aluminum suspension mounts.
Forum: Redcat Racing Support
09-08-2014, 11:36 AM
Replies: 4
Views: 768
Posted By Redcat James

It sounds like your vehicle was cogging and when...

It sounds like your vehicle was cogging and when you continued to try and drive it it made the esc and motor very hot until it blew up. Normally the cause for that is a bad esc but now your motor may...
Forum: Redcat Racing Support
09-02-2014, 10:42 AM
Replies: 4
Views: 585
Posted By Redcat James

06045 is the direct replacement.

06045 is the direct replacement.
Forum: Redcat Racing Support
09-02-2014, 10:33 AM
Replies: 1
Views: 666
Posted By Redcat James

I would give Redcat a call at (602)454-6445 when...

I would give Redcat a call at (602)454-6445 when you have the vehicle in front of you and they should be able to assist you over the phone, should be covered under warranty.
Forum: Redcat Racing Support
08-20-2014, 08:27 AM
Replies: 9
Views: 2,972
Posted By Redcat James

2.4 is the radio

2.4 is the radio
Forum: Redcat Racing Support
08-19-2014, 08:33 AM
Replies: 3
Views: 651
Posted By Redcat James

That should work just fine.

That should work just fine.
Forum: Redcat Racing Support
08-19-2014, 08:24 AM
Replies: 9
Views: 2,972
Posted By Redcat James

The new Earthquakes come with a black cooling...

The new Earthquakes come with a black cooling head and short antenna since they are 2.4. If your engine won't turn over from what I've seen the pinch on the new engines is extra tight. You can use a...
Forum: Redcat Racing Support
08-19-2014, 08:16 AM
Replies: 7
Views: 733
Posted By Redcat James

If the gear mesh is properly adjusted and no...

If the gear mesh is properly adjusted and no rocks go through the gears it should last a lot longer. You can loosen the slipper to prevent the gears from absorbing all the shock in the drivetrain,...
Forum: Redcat Racing Support
08-15-2014, 08:39 AM
Replies: 3
Views: 1,330
Posted By Redcat James

Did you use shoulder screws, do you have a...

Did you use shoulder screws, do you have a picture of them? Yes they come from the factory threaded into plastic :(
Forum: Redcat Racing Support
08-15-2014, 08:37 AM
Replies: 3
Views: 651
Posted By Redcat James

As long as you keep it under 250 degrees you...

As long as you keep it under 250 degrees you should be fine.
Forum: Redcat Racing Support
08-11-2014, 09:46 AM
Replies: 1
Views: 442
Posted By Redcat James

Here you go...

Here you go http://www.redcatracing.com/s.nl/it.A/id.2236/.f
Forum: Redcat Racing Support
08-04-2014, 09:37 AM
Replies: 5
Views: 542
Posted By Redcat James

24620 is for 2.4 and is the latest...

24620 is for 2.4 and is the latest version...............
Forum: Redcat Racing Support
08-04-2014, 09:34 AM
Replies: 2
Views: 559
Posted By Redcat James

So you're saying the motor won't slide out far...

So you're saying the motor won't slide out far enough to install the larger gear?
Forum: Redcat Racing Support
07-22-2014, 01:34 PM
Replies: 3
Views: 1,616
Posted By Redcat James

I would reset the needle settings to the stock...

I would reset the needle settings to the stock settings. Turn both the high and low speed needles clockwise until they bottom out. Back the high speed needle out 3-1/2 turns and the low speed 2-1/4...
Forum: Redcat Racing Support
07-21-2014, 01:12 PM
Replies: 3
Views: 1,616
Posted By Redcat James

I would recheck the needle settings, the idle...

I would recheck the needle settings, the idle setting and the clutch. I would also check the glow plug.
Forum: Redcat Racing Support
07-21-2014, 01:07 PM
Replies: 2
Views: 535
Posted By Redcat James

Where is the ST/DR knob set to?

Where is the ST/DR knob set to?
Forum: Redcat Racing Support
07-16-2014, 11:31 AM
Replies: 1
Views: 467
Posted By Redcat James

http://www.redcatracing.com/02092

http://www.redcatracing.com/02092
Forum: Redcat Racing Support
07-09-2014, 07:22 AM
Replies: 9
Views: 1,163
Posted By Redcat James

Actually we say that because the esc, motor and...

Actually we say that because the esc, motor and gearing are designed for 2s lipo.
Forum: Redcat Racing Support
07-08-2014, 01:57 PM
Replies: 6
Views: 1,635
Posted By Redcat James

http://www.redcatracing.com/108839

http://www.redcatracing.com/108839
Forum: Redcat Racing Support
07-08-2014, 01:54 PM
Replies: 9
Views: 1,163
Posted By Redcat James

The Tornado EPX Pro is only rated out of the box...

The Tornado EPX Pro is only rated out of the box for a 2s lipo battery, adding a 3rd cell will void the warranty.
Forum: Redcat Racing Support
07-02-2014, 07:40 AM
Replies: 8
Views: 1,657
Posted By Redcat James

Did you try the dual rate knob? It should be set...

Did you try the dual rate knob? It should be set to 6. There is no end point adjustment on a Tornado controller.
Forum: Redcat Racing Support
06-17-2014, 07:54 AM
Replies: 1
Views: 1,049
Posted By Redcat James

This is a different esc but the manual and set up...

This is a different esc but the manual and set up are the same. Click the manual link under description http://www.redcatracing.com/03351
Forum: Redcat Racing Support
06-17-2014, 07:42 AM
Replies: 3
Views: 605
Posted By Redcat James

Maybe the engine is overheating. Try richening it...

Maybe the engine is overheating. Try richening it up.
Forum: Redcat Racing Support
06-17-2014, 07:39 AM
Replies: 11
Views: 650
Posted By Redcat James

If the car is on the ground and you slowly pull...

If the car is on the ground and you slowly pull the pull starter up, will the car stay on the ground or come up with the pull start?
Showing results 1 to 25 of 77
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.