RCU Forums - Search Results

Search: Posts Made By: bmcd

Showing results 1 to 5 of 5
Search took 0.05 seconds.

Forum: Gas Engines

01-15-2015, 03:02 AM

Replies: 2,224

New Evolution 10cc gas engine

Views: 445,704

Posted By bmcd

Opened my LS needle slightly to check the effect...

Opened my LS needle slightly to check the effect on "idle hang". No difference, so I returned it to where it was. Following Al's advice - It's not an issue so I will live with it.

@Steve
My idle...

Forum: Gas Engines

01-09-2015, 11:00 AM

Replies: 2,224

New Evolution 10cc gas engine

Views: 445,704

Posted By bmcd

I must check my idle RPM on the tacho. Never done...

I must check my idle RPM on the tacho. Never done that.

I read all the muffler issues before the first run. Following a wise 10GX owner at the club, I epoxied all three sections together and both...

Forum: Gas Engines

01-08-2015, 12:15 PM

Replies: 2,224

New Evolution 10cc gas engine

Views: 445,704

Posted By bmcd

Thanks Brian, ahicks I will open the LS...

Thanks Brian, ahicks

I will open the LS needle a tad this Saturday. The engine was peaked just before the tacho reading. Note my temp was 28 degC (82.4 degF).
Linkage, servo, tank & lines are OK....

Forum: Gas Engines

01-08-2015, 04:47 AM

Replies: 2,224

New Evolution 10cc gas engine

Views: 445,704

Posted By bmcd

Hi all My 10GX has done about 8-10 litres and...

Hi all
My 10GX has done about 8-10 litres and runs a 13x6 APC. I am getting 9450 RPM on the ground. Idle to max transition seems ok but after WOT for a few secs, the return to idle takes about 7...

Forum: Gas Engines

12-19-2014, 09:56 PM

Replies: 2,224

New Evolution 10cc gas engine

Views: 445,704

Posted By bmcd

Just a thought on filling from the carb line. Any...

Just a thought on filling from the carb line. Any dirt in the fuel will be on the wrong side of the clunk filter. The 3 line setup with separate fill line avoids this.

Showing results 1 to 5 of 5