RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: motie
Showing results 1 to 6 of 6
Search took 0.04 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
11-09-2015, 10:03 AM
Replies: 3
Views: 590
Posted By motie

I think I found a good solution: a breaker with...

I think I found a good solution: a breaker with automatic reset. http://www.snapaction.net/pdf/MX5%20Spec%20Sheet.pdf . It takes 3 - 5 seconds to reset itself after tripping. During that time,...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
11-07-2015, 03:29 PM
Replies: 3
Views: 590
Posted By motie

I was hoping I could do it without disabling the...

I was hoping I could do it without disabling the robot.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
11-06-2015, 10:12 AM
Replies: 3
Views: 590
Posted By motie

stall protection

We are using a Traxxas 3014 speed controller with an RS-550 motor for driving the wheels on a robot vehicle. We are trying to design for high reliability. How can we protect the controller and...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-07-2015, 09:07 AM
Replies: 4
Views: 584
Posted By motie

My design experience is in industrial and...

My design experience is in industrial and aerospace, where nearly all electronics runs on regulated power supplies. So I need to learn about batteries.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
10-07-2015, 04:03 AM
Replies: 4
Views: 584
Posted By motie

Is there a preferred battery voltage for new R/C gear?

We are upgrading an old military robot (Marcbot) with recent-vintage R/C blocks. It looks to me like a lot of the new stuff wants a two-cell LiPo pack. If you were doing a new R/C system, would you...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
09-17-2015, 04:17 AM
Replies: 12
Views: 13,470
Posted By motie

Does the HFD-08RD use PPM, PCM, or some other...

Does the HFD-08RD use PPM, PCM, or some other kind of signal format? Thanks.
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.