RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: caliber90
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: RC Jets
08-04-2023, 06:49 PM
Replies: 1,148
Views: 415,286
Posted By caliber90

I use 45mm JP wheels at the rear, 40mm at the...

I use 45mm JP wheels at the rear, 40mm at the front. I want the nose pointing a bit lower on the ground. Beware, my M Avanti take off and land on asphalt.

If larger wheel size is used, it...
Forum: RC Jets
07-07-2021, 06:39 PM
Replies: 1,148
Views: 415,286
Posted By caliber90

I bought spare pins from JP for those oleo under...

I bought spare pins from JP for those oleo under the wings. I just bent the front pin cccasionally. When this happens, I took the nose retract out, put it on a vice grip and bent it back to straight....
Forum: RC Jets
11-08-2019, 07:54 PM
Replies: 1,148
Views: 415,286
Posted By caliber90

1. I don’t have any data to tell but I trust...

1. I don’t have any data to tell but I trust their engine spec, like the idle thrust is minimal, similar to what they say,
3. I am using Mobil jet oil, no abnormally found
3. My UAT is made by...
Forum: RC Jets
08-28-2019, 07:56 PM
Replies: 1,148
Views: 415,286
Posted By caliber90

Thanks for sharing. I use 1450 2S LiPo for...

Thanks for sharing.

I use 1450 2S LiPo for both Rx and turbine. Both consume less than 200mAh each flight, with the one for turbine consumes slightly less. I was wondering why not combine the 2...
Forum: RC Jets
08-27-2019, 06:42 PM
Replies: 1,148
Views: 415,286
Posted By caliber90

Nice flight and nice field. What are the capacity...

Nice flight and nice field. What are the capacity of batteries on board?

Mine is with X45 and the performance is great, only that my TOW is no where near 4.2kg.
Forum: RC Jets
08-11-2019, 06:50 PM
Replies: 1,148
Views: 415,286
Posted By caliber90

My X45 powered Avanti has done over 20 flights,...

My X45 powered Avanti has done over 20 flights, so far very good.

I don't know what "standard servos" you refer to. I put Futaba HV servos in my avanti. I use 2 Optipower LiPo 1450 2S packs, one...
Forum: RC Jets
05-22-2019, 06:52 PM
Replies: 150
Views: 69,697
Posted By caliber90

I am about to start the building of my XS. I am...

I am about to start the building of my XS. I am going to put K120 into it. I see in the tail the servo wires are exposed and subjected to the heat from the pipe before going into the tube. Is there...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.