RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: low701
Showing results 1 to 6 of 6
Search took 0.02 seconds.
Forum: YS Engines Support
06-30-2020, 09:51 AM
Replies: 8
Views: 4,051
Posted By low701

It is a DZ. problem above was my rebuilding the...

It is a DZ. problem above was my rebuilding the engine incorrectly!
lessons now learnt the engine has been fine ever since.
And yes following some other advice I have just made a switched glowplug...
Forum: YS Engines Support
05-19-2020, 08:44 AM
Replies: 8
Views: 4,051
Posted By low701

Quick update. Thought I had learnt how to...

Quick update.
Thought I had learnt how to handle this engine now.
Previous problems all down to running too rich.

Tried to run it in the airframe today, first time with engine inverted. It’s now...
Forum: YS Engines Support
04-03-2020, 11:48 PM
Replies: 8
Views: 4,051
Posted By low701

Thanks Gents, I still have not figured out why...

Thanks Gents,
I still have not figured out why the engine stopped suddenly while on a fast tickover. I was setting the throttle end points at the time trying to achieve a reliable slow tick-over.
I...
Forum: YS Engines Support
04-01-2020, 08:37 AM
Replies: 8
Views: 4,051
Posted By low701

Whipped rocker cover off. Turned over by hand,...

Whipped rocker cover off. Turned over by hand, Both valves working, decent compression.
Put my new starter on the front and gave it a spin.
Felt ok for 2 seconds then both valves stopped working....
Forum: YS Engines Support
03-22-2020, 01:23 AM
Replies: 8
Views: 4,051
Posted By low701

Further to my first post I used the wrong...

Further to my first post I used the wrong terminology. The engine stopped while on fast tickover while trying to set low throttle position on the servo.
Havent run the engine at WOT yet.
Forum: YS Engines Support
03-19-2020, 02:51 AM
Replies: 8
Views: 4,051
Posted By low701

YS170 Sudden Dead Stop from Fast Idle

I was running my newly purchased second hand YS170 for the third time in the air-frame in preparation for a first flight.
I was setting up the existing throttle servo end points to match my RC...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.