RCU Forums - Search Results

Search: Posts Made By: Chrisg81983

Showing results 1 to 5 of 5
Search took 0.02 seconds.

Forum: Speed - Electric

04-30-2020, 06:21 AM

Replies: 246

Norbert's 1.1m balsa cat build

Views: 59,730

Posted By Chrisg81983

Hello all i know its been a while and might be a...

Hello all i know its been a while and might be a long shot, but would someone have these plans. Thanks in advance.

Forum: Speed - Electric

04-18-2020, 06:45 PM

Replies: 5

Advice for Engineering Test Bed Build

Views: 1,325

Posted By Chrisg81983

Wow would really love to see this, but I would...

Wow would really love to see this, but I would definitely use a big outrunner or big lehner. I would also use a mgm 400/63 controller. I mainly run mgm with lehner and can pull some crazy numbers...

Forum: Speed - Electric

04-18-2020, 05:10 PM

Replies: 5

Advice for Engineering Test Bed Build

Views: 1,325

Posted By Chrisg81983

You are going to need one heck of a prop with...

You are going to need one heck of a prop with only 7,000 rpm.... what props are you thinking of ???

Forum: Speed - Electric

04-18-2020, 05:06 PM

Replies: 2

This might be a stupid question

Views: 1,128

Posted By Chrisg81983

Overall efficiency.... the 3s setup will be more...

Overall efficiency.... the 3s setup will be more stress on electronics. I use Lehner motors and have the choice to run in delta or wye. On my motors in wye configurations is say around 1010 KV and in...

Forum: Speed - Electric

04-18-2020, 04:55 PM

Replies: 16

Batter plug size. Motor kv size. For 6s 8s 12s

Views: 6,812

Posted By Chrisg81983

On boats over 40 inches i use 1/4 / 6.35 mm flex...

On boats over 40 inches i use 1/4 / 6.35 mm flex and a 8mm prop shaft but then step down from drivedog forward to accept 3/16 props as you get a much better selection. All other boats smaller in...

Showing results 1 to 5 of 5