RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: GarbMan
Showing results 1 to 25 of 65
Search took 0.62 seconds.
Forum: RC Painting, Detailing & Bodies
07-28-2006, 05:48 AM
Replies: 1
Views: 628
Posted By GarbMan

Where can I download decals for my airplane?

I've tried to download some various pictures, but they usually have more colors then I need. One I want is a UT (University of Tennessee) emblem. One of the problems I have is the resolution. Once...
Forum: Beginners
05-30-2006, 05:56 AM
Replies: 12
Views: 2,977
Posted By GarbMan

RE: I need help identifying Rx. Is is single or dual conversion?

So what ever I use these receivers for, I must use single conversion crystals. Is this right?

I wonder if they are low or high band. I was hoping to us channel 30 and 46. I think both of...
Forum: Beginners
05-29-2006, 08:54 AM
Replies: 12
Views: 2,977
Posted By GarbMan

RE: I need help identifying Rx. Is is single or dual conversion?

Here is the info and also a link to what I bought. I bought the 72Mhz.

New Futaba Type 6 Channel FM Receiver
Model Number : rcps81402

35/40/72Mhz Avaliable

You are looking at a...
Forum: Beginners
05-28-2006, 11:06 PM
Replies: 12
Views: 2,977
Posted By GarbMan

RE: I need help identifying Rx. Is is single or dual conversion?

I contacted the seller. This is what he had to say:

"Hi there,

The receiver itself is single conversion. : )

The range of the receiver you have received is 500m which is same as the...
Forum: Beginners
05-28-2006, 03:13 AM
Replies: 12
Views: 2,977
Posted By GarbMan

I need help identifying Rx. Is is single or dual conversion?

I bought a couple of Rx's really cheap off eBay. They just say TurBorix FM/PPM and are 6 channel. There is a website labeled on them. It is

http://rvminc.net

However, the Rx's are not...
Forum: RC Helicopter Beginners Forum
09-15-2004, 12:14 AM
Replies: 15
Views: 1,721
Posted By GarbMan

RE: Problem w Hummingbird.... HELP, NEWBIE !!!

Don't forget about the TX. What if for some reason something happen to the TX and it's not sending out enough movement. Try another TX. I know nothing of Heli's. But if everything checks on the...
Forum: Questions and Answers
08-16-2004, 01:49 AM
Replies: 13
Views: 2,751
Posted By GarbMan

RE: Home Made Runway?

I can land it tall grass ok. I just need to takeoff.
Forum: Questions and Answers
08-13-2004, 04:47 AM
Replies: 13
Views: 2,751
Posted By GarbMan

RE: Home Made Runway?

A tarp that is staked out tight might work. It would need to be very tight so it would remain flat and smooth. I think the tarp would still sink down in the ground were there are low places. ...
Forum: Questions and Answers
08-13-2004, 12:09 AM
Replies: 13
Views: 2,751
Posted By GarbMan

Home Made Runway?

This may sound crazy but I'm looking to make a runway. I have access to plenty of land to fly, but the problem is take off. The ground is too rough for take off and I don't want to tear up the...
Forum: Glow Engines
08-11-2004, 02:07 PM
Replies: 7
Views: 887
Posted By GarbMan

RE: Tower Hobbies 46 ABC Engine Won't Idle!

I just got this engine. I bought it off Ebay. The person I bought it from said he ran 5 tanks of fuel through it but never flew it.
Forum: Glow Engines
08-10-2004, 10:51 PM
Replies: 7
Views: 887
Posted By GarbMan

RE: Tower Hobbies 46 ABC Engine Won't Idle!

So, is this Tower Hobbies engine like a GMS? Is it a GMS engine with Tower Hobbies name on it? From the picture it looks just like one. Is there a problem with this engine shuting down? I've read...
Forum: Glow Engines
08-10-2004, 02:48 AM
Replies: 7
Views: 887
Posted By GarbMan

RE: Tower Hobbies 46 ABC Engine Won't Idle!

How do I delete this post?
Forum: Glow Engines
08-10-2004, 02:09 AM
Replies: 7
Views: 887
Posted By GarbMan

Tower Hobbies 46 ABC Engine Won't Idle!

This engine has only 5 tanks of fuel ran through it. It runs fine at high speed but won't idle without choking. If you rich up the mixture, it may idle a little, but is way too rich to run at high...
Forum: Gas Engines
08-06-2004, 11:23 PM
Replies: 3
Views: 523
Posted By GarbMan

RE: Homelite 45cc Problems.

I've decided to get another engine. This will give me the opportunity to change out parts and figure out which part is bad. I'm going to switch ignitions and carbs first thing. I will sell one or...
Forum: Gas Engines
08-06-2004, 02:43 AM
Replies: 3
Views: 523
Posted By GarbMan

Homelite 45cc Problems.

I think this engine is shot. I don't want to tell the same story over, but I do need your opinion on the subject. Please visit this link where I discuss all that I have done and all the tests I've...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-02-2004, 12:35 AM
Replies: 10
Views: 1,200
Posted By GarbMan

RE: Where do I find a schematic for the Futaba 4 ch TX?

I still haven't identified channel 6 and 7. It may be above my knowledge to add these two. The added channels would be good for the sims. I have been informed that by FCC law it is illegal to use...
Forum: Questions and Answers
07-31-2004, 12:51 AM
Replies: 1
Views: 731
Posted By GarbMan

Where so I find Info for a Cirrus HS-874 Receiver?

This is a 7 Channel AM receiver, but I can not find anything about. It's as if it never exsisted. I was hoping to identify which plugs are channels 5, 6, and 7. Channels 1-4 are marked, but 5, 6,...
Forum: Questions and Answers
07-28-2004, 01:10 AM
Replies: 8
Views: 729
Posted By GarbMan

RE: Where Do I get the Metal Battery Stips for Futaba Radio?

Yes, your right Rodney. I don't think I want to make my own battery pack. However, I have noticed that even the ones with the plugs and wires have the same problem. The wires turn black and the...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-28-2004, 12:59 AM
Replies: 10
Views: 1,200
Posted By GarbMan

RE: Where do I find a schematic for the Futaba 4 ch TX?

I added a 5th Channel to the Skysport 4. It works like a dream. Here's the link: http://home.planet.nl/~toore015/RC.htm

It's great for sims too.

Thanks guys for the info. Well, I've...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-27-2004, 01:27 PM
Replies: 10
Views: 1,200
Posted By GarbMan

RE: Where do I find a schematic for the Futaba 4 ch TX?

No, the chip is not the NE5004. It is a 32 pin chip found in the Futaba Skysport 4 Channel. It has the Futaba name on the chip and has two sets of numbers on it. FP6335 and 310 143100.
Forum: Questions and Answers
07-26-2004, 11:59 AM
Replies: 8
Views: 729
Posted By GarbMan

RE: Where Do I get the Metal Battery Stips for Futaba Radio?

Thanks for the info. I did not know about the oxidizing problem. I already use them in some other TX's. I bought the battery holders for the AA. They have the compressed fittings. Will this be a...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-26-2004, 03:04 AM
Replies: 10
Views: 1,200
Posted By GarbMan

RE: Where do I find a schematic for the Futaba 4 ch TX?

I'm trying to identify the pinout of the main chip on the circuit board. I have learn some from this post:

http://www.rcuniverse.com/forum/4_to_5_channel%3F/m_1958892/tm.htm

But my chip is...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-26-2004, 01:04 AM
Replies: 10
Views: 1,200
Posted By GarbMan

Where do I find a schematic for the Futaba 4 ch TX?

I guess this is about impossible to find. I, at least want to know the numbering of the pins. Can someone help me?
Forum: Questions and Answers
07-26-2004, 12:56 AM
Replies: 8
Views: 729
Posted By GarbMan

Where Do I get the Metal Battery Stips for Futaba Radio?

It looks like my Futaba radio was made to except AA batteries, but the little flat metal strips that connect each of the batteries are not included in the radio. I would like to use the Energizer...
Forum: Beginners
07-09-2004, 10:07 PM
Replies: 14
Views: 6,540
Posted By GarbMan

RE: Performance Mods for Glow Engines?

Is this the same leaking problem that I've been reading about on the GMS engines? By the way, who manufactures the Tower Hobbies engines? It's not GMS is it?
Showing results 1 to 25 of 65
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.