RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: HOLMES
Showing results 1 to 25 of 73
Search took 0.63 seconds.
Forum: Losi Monster Trucks
07-26-2005, 07:30 AM
Replies: 11
Views: 633
Posted By HOLMES

RE: Possible to start a V-Spec?

The crank on the os v-spec is not made to accept a pullstart .
Forum: Losi Monster Trucks
07-11-2005, 09:30 PM
Replies: 9
Views: 480
Posted By HOLMES

RE: Front Differential

I have went through about ten diffs . It has always been the pinnion and ring gear . I was told that it was not shimmed right and he is probably right . Most of the time this happens is on braking or...
Forum: Losi Monster Trucks
07-08-2005, 07:54 AM
Replies: 6
Views: 961
Posted By HOLMES

RE: Super King Pin Foams

I ordered new foams , the firm grey ones . I only cut off the mounting bead . If they are already mounted you just cut right along the old wheel . If not there is a grove or a line right above the...
Forum: Losi Monster Trucks
07-07-2005, 04:56 PM
Replies: 6
Views: 961
Posted By HOLMES

RE: Super King Pin Foams

I ran the 2 stage and they sucked . The proline foams are to narrow so you are kind of stuck with the losi foams . I mounted mine on 40 series wheels and put in new foams and they seem to be holding...
Forum: Losi Monster Trucks
07-07-2005, 04:54 PM
Replies: 30
Views: 1,750
Posted By HOLMES

RE: Muddy LST

I was practicing tues night and completely submerged my lst in a mud puddle . I had to tear apart the whole truck . 2d I clean my tires after every heat but I don't submerge mine in water or hose...
Forum: Losi Monster Trucks
06-30-2005, 10:50 PM
Replies: 30
Views: 1,750
Posted By HOLMES

RE: Muddy LST

I use a tooth brush , a craft brush( like a round paint brush) and a mix of simple green and denatured alcohol . I lnock of all of the loose stuff with a air compressor , use the brushes to clean and...
Forum: Losi Monster Trucks
06-30-2005, 10:45 PM
Replies: 12
Views: 715
Posted By HOLMES

RE: hard to start when hot

Sounds like the low end is to lean . The engine may not be getting enough fuel . This usualy happens when the truck gets to hot .
Forum: Losi Monster Trucks
06-21-2005, 09:47 PM
Replies: 5
Views: 625
Posted By HOLMES

RE: Racing an LST in Truggy class

Next year the pro series is calling the truggy class 1/8 scale stadium truck . I hope alot of the tracks will opt to use the pro series rules .
Forum: Losi Monster Trucks
05-13-2005, 01:20 PM
Replies: 10
Views: 1,311
Posted By HOLMES

RE: Duckt tape in tires??

I have done this to tires on my truggy and lst . Its works good but I used fiber tape .
Forum: Losi Monster Trucks
05-06-2005, 11:04 AM
Replies: 6
Views: 935
Posted By HOLMES

RE: Losi Super King Pins on 40 series?

They have the offset of a revo wheel .
Forum: Losi Monster Trucks
05-06-2005, 07:56 AM
Replies: 6
Views: 935
Posted By HOLMES

RE: Losi Super King Pins on 40 series?

Sweet :D
Forum: Losi Monster Trucks
05-05-2005, 09:40 PM
Replies: 6
Views: 935
Posted By HOLMES

RE: Losi Super King Pins on 40 series?

I posted a couple of weeks ago that I was going to try this :D How much did you cut off and how well did they mount up , to the bead of the wheel ?
Forum: Losi Monster Trucks
04-28-2005, 10:13 PM
Replies: 21
Views: 1,107
Posted By HOLMES

RE: King pins review

The top of the 2 stage foam is to soft . The stock foams are much more firm .
Forum: Losi Monster Trucks
04-22-2005, 11:44 AM
Replies: 21
Views: 1,107
Posted By HOLMES

RE: King pins review

I put the 2 stage in mine but I ordered the stock ones yesterday to replace them .
Forum: Losi Monster Trucks
04-20-2005, 07:41 PM
Replies: 32
Views: 2,054
Posted By HOLMES

RE: Motor Temp

I run mine at around 200 to 220 . I don't think the temp really matters until the truck starts to lean bog . The only thing with useing after market cooling heads is if you run the motor lean at...
Forum: Losi Monster Trucks
04-19-2005, 09:38 PM
Replies: 15
Views: 578
Posted By HOLMES

RE: LST Overrev!

There should not be air bubbles in the tank or line . The bubbles or having air in the line is what is causing the erratic idle . The air leans out the tune of the engine
Forum: Losi Monster Trucks
04-18-2005, 11:11 PM
Replies: 15
Views: 885
Posted By HOLMES

RE: racing setup help!!

I think they said the end of may on the one way . I also would'nt worry about the weight difference when it come to upgrading to titanium hing pins and turnbuckles . This is one of the best upgrades...
Forum: Losi Monster Trucks
04-18-2005, 11:02 PM
Replies: 21
Views: 1,107
Posted By HOLMES

RE: King pins review

I have had mine since the first day they were released . At first I liked them and knew they would be good for outdoors not indoors . But I tried them with good results indoors at crcrc but now they...
Forum: Losi Monster Trucks
04-17-2005, 11:46 PM
Replies: 15
Views: 885
Posted By HOLMES

RE: racing setup help!!

Is the track a oval ? If so using the bowties or a smaller tire would be alright because of the short straight . The truck will have more torque and get up to speed quicker . Try 50th diff oil since...
Forum: Losi Monster Trucks
04-13-2005, 02:49 PM
Replies: 7
Views: 704
Posted By HOLMES

RE: so what is your final high-speed needle setting

They type of plug and climate changes what your needle settings are at . This is something to look out for when using someone elses settings .
Forum: Losi Monster Trucks
04-11-2005, 10:36 PM
Replies: 8
Views: 527
Posted By HOLMES

RE: my motor done kicked the can!

My rod shot through my case also . I have yet had time to send it in .
Forum: Losi Monster Trucks
04-06-2005, 09:45 PM
Replies: 38
Views: 2,854
Posted By HOLMES

RE: sh.28 not so good!!!

The SH .28 I believe it is made by golden lion and distributed by xtm .
Forum: Losi Monster Trucks
04-06-2005, 09:40 PM
Replies: 12
Views: 544
Posted By HOLMES

RE: Quick help please

With your radio and truck on but not running push the truck forward to see if the brakes or something else is dragging . This would be a good place to start to make sure it is not a mechanical...
Forum: Losi Monster Trucks
04-06-2005, 06:51 AM
Replies: 30
Views: 2,273
Posted By HOLMES

RE: LST Expert Owners Only!

You also might want to get some lunsfurd titanium tie rods . And there is a guy on here that bent his aluminum a-arms (worldsfastestsupra)
Forum: Losi Monster Trucks
04-04-2005, 07:55 PM
Replies: 6
Views: 610
Posted By HOLMES

RE: Has anyone ran their Super King pins yet?

I like them :D I have been running the hot bodie tires so my shift point needs adjusted . I don't realy want to change anything like that at the track so I'm planning on adjusting it this week when i...
Showing results 1 to 25 of 73
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.