RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: dinorc
Showing results 1 to 25 of 80
Search took 0.61 seconds.
02-09-2014, 02:13 AM
Replies: 4
Views: 941
Posted By dinorc

I have the exact same problem, wrote twice to...

I have the exact same problem, wrote twice to FsOne support about ten days ago, but even though they claim answers within one working day...I did not get an answer yet...
Details: upgraded from...
Replies: 1
Views: 408
Posted By dinorc

Altitude telemetry and TaranisTX

Unable to get a connection between tha altitude sensor and a Taranis Tx via a Frsky DR8 II receiver.
Any help and suggestions will be thoroughly appreciated.
Thank you.
Regards.
Dino
Replies: 3
Views: 1,416
Posted By dinorc

Dymond servos

Hi everybody,
I have several Dymond servos mod 9500 purchased from Modellhobby.de approximately one and a half years ago.
One aileron servo, after about 50 flights, started jittering...
05-30-2012, 12:56 AM
Replies: 13
Views: 10,028
Posted By dinorc

RE: DLE 30 Pitts wrap around

Hi, it's a direct bolt-on replacement. Fits fine with regards to the firewall. I installed mine in a Sbach342 and had to cut the two exhaust tubes by 1" to be able to install and remove engine...
Forum: Gas Engines
05-28-2012, 12:06 AM
Replies: 9
Views: 1,415
Posted By dinorc

Mintor 33 conrod

Hello,
I have read an italian forum where several Mintor 33 users are complaining about experiencing conrod problems...It appears that the problem does not occur in the Mintor 55.....
Anybody...
Forum: Gas Engines
05-14-2012, 10:44 PM
Replies: 13
Views: 1,298
Posted By dinorc

DLE 30 cyl replacement

Hello,
I have broken a few cooling fins on my DLE 30 Head (landing gear broken off and...'[>:]',). Replacing it means replacing the cylinder. The engine is barely broken-in, is it safe not to...
Forum: Gas Engines
03-27-2012, 10:17 PM
Replies: 9
Views: 2,121
Posted By dinorc

RE: Dle 30 dies in takeoff

Hello, I have solved the problem by letting the carb draw air from inside the fuselage! The photos attached show how simply I did this by using dense foam rubber around the firewall hole.
To...
Forum: Gas Engines
03-20-2012, 11:38 PM
Replies: 9
Views: 2,121
Posted By dinorc

RE: Dle 30 dies in takeoff

Hi, checked the fuel tank, unfortunately all fuel lines are in good order. Disassembled the carb, no dirt found, but the diaphragm/needle lever seems to be too low below the carb face. Anybody knows...
Forum: Gas Engines
03-19-2012, 10:48 PM
Replies: 9
Views: 2,121
Posted By dinorc

RE: Dle 30 dies in takeoff

Hello Mike, thanks for the suggestion, I shall recheck the internal tank fuel lines ( done last week before flying ) even though I do not quite understand why the engine ran perfectly on the ground...
Forum: Gas Engines
03-19-2012, 09:02 AM
Replies: 9
Views: 2,121
Posted By dinorc

Dle 30 dies in takeoff

Hi, my DLE 30 dies in take off; as soon as it picks up speed it dies! It used to work properly until I decided to do a better job with the weights that I installed as far forward under the "box".
...
Forum: Beginners
02-14-2012, 01:34 AM
Replies: 25
Views: 2,906
Posted By dinorc

RE: Simulators

I am also using the FSOne. Like it a lot since I can use my own TX(JR9303) wireless using the adapter. I use it with the Hangar 9 extra and kep my Tx settings, I have a safety switch programmed that...
Replies: 16
Views: 2,584
Posted By dinorc

RE: Terrible service from Horizon Hobby

I live in Italy, please refer to my post:"Spektrum Evolution Receiver"...but I e-mailed HH in the USA....same treatment....No further comments!
Dino
Replies: 2
Views: 523
Posted By dinorc

Spektrum Evolution Rx

Hello all,
I have this 9ch rx that came with 2 hi energy leds to be able and see, in flight, if batteries are ok.
Unfortunately they do not light up when connected to the appropriate Rx...
01-06-2012, 09:34 AM
Replies: 2
Views: 725
Posted By dinorc

RE: Zlin

Hello Ken,
thanks for updating me on the Zlin. I would like to see at least the ad, but I do not have the LDS link.
Can you help?
I have just started a Chipmunk fromAirsail, not a...
12-13-2011, 10:00 AM
Replies: 14
Views: 1,907
Posted By dinorc

RE: JR 9303 programming

Thanks again KC...I'll try as soon as possible, so if tomorrow weather is OK here in Roma (Italy) i shall test the model.
Will certainly let you know the results.
Dino
12-13-2011, 09:48 AM
Replies: 14
Views: 1,907
Posted By dinorc

RE: JR 9303 programming

Hi KC,
first of all thank you for a quick reply; very much appreciated but,....I have already set the Mix switch to channel Aux 4.
I am also using the throttle curve to optimize the response...
12-13-2011, 01:27 AM
Replies: 14
Views: 1,907
Posted By dinorc

JR 9303 programming

Hello,
I have been trying to program my TX to allow a switch to limit the travel of the throttle slightly above idle for safety reasons (on the ground).
The reason for this is what happened...
11-22-2011, 12:54 AM
Replies: 5
Views: 1,495
Posted By dinorc

Zlin Z.126 or Z.526

Hi,
does anybody know if an ARF is available for these models? I am looking for a model with approximately 170/180 cm wing span to be powered wit an RCV 130 (inline) 4 stroke engine.
If not...
11-15-2011, 12:03 AM
Replies: 0
Views: 643
Posted By dinorc

FSOne and JR9303 TX

Hi,
I have had this sim for quite a while. Recently I needed some training and started using it again, but I have 2 problems. The Extra model does not show anymore the various JR TXs available two...
Forum: Gas Engines
10-11-2011, 07:47 AM
Replies: 20
Views: 3,995
Posted By dinorc

RE: DLE carb repair

Heyyy, thanks! I should be back in business (flying) shortly.
If you need something about Rome, Italy, just ask.
Dino
Forum: Gas Engines
10-11-2011, 01:27 AM
Replies: 20
Views: 3,995
Posted By dinorc

DLE carb repair

Hi,
I crashed my model and as a result the fuel nipple on the carb broke. The carb is marked "DLE" and the fuel nipple is made of a plastic fitting installed in the carb body. I would like...
Forum: Gas Engines
10-11-2011, 01:21 AM
Replies: 70
Views: 9,798
Posted By dinorc

RE: DLE30 experiences please

Hi, I have a 72" Sbach mfd by Flying models and powered with a DLE 30 rear carb.
Engine is great, still not fully broken in, using an 18x8 wood prop.
A very, very good, experienced 3D flyer...
07-20-2011, 12:47 AM
Replies: 1
Views: 1,049
Posted By dinorc

Spektrum Power Box Receiver

I have been using tis combination for quite a few months without any problems , but every time I finish flying I notice that battery 1 has been discharged while battery 2 appears to not have been...
Replies: 0
Views: 440
Posted By dinorc

Spektrum Power Box 9 ch RX

I have been using this RX combination succesfully but I have a question on batteries usage:
Only battery 1 seems to be in use, is battery 2 meant to be only a back-up that becomes active after...
Replies: 29
Views: 6,000
Posted By dinorc

RE: JR R921 Receiver battery question

Hello all,
I am usinh a "Spektrum Power Box Rx" with two A123 LiFe batteries connected via the 2 Mpx sockets and when I go home to recharge the batteries the one on side 1 is...
Showing results 1 to 25 of 80
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.