RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: creyc
Showing results 1 to 25 of 500
Search took 2.30 seconds.
Forum: Multi Rotor Helicopters
12-16-2013, 07:48 PM
Replies: 1
Views: 434
Posted By creyc

First quad build, please help me select parts that won't end up as a fireball

I've been around R/C for a while but this is my first time venturing off the surface and into the air. My goal is to build a nice little quadcopter that can eventually fly around with my GoPro....
Forum: RC Electric On-Road vehicles, race cars and more
03-14-2008, 03:55 PM
Replies: 2
Views: 450
Posted By creyc

TC3 bad turning ratio at high speeds

My TC3 doesn't steer as well as I wish it would at moderate-high speeds.

When I'm idling along at low speed I can turn the car around in a few feet. When I'm on the throttle, even half...
Forum: Traxxas Monster Truck forum
06-17-2006, 10:22 PM
Replies: 2
Views: 426
Posted By creyc

Downsizing to a revo?

I've long been an RC hobbyist, and owned a fair share of off and on road vehicles both electric and gas over the years. My latest truck was a Team Losi LST and sadly I've had nothing but problems...
Forum: RC Drifting
04-02-2005, 10:34 PM
Replies: 15
Views: 1,008
Posted By creyc

RE: drifting after a good rain

and likely the receiver too.
Forum: Losi Monster Trucks
04-02-2005, 10:32 PM
Replies: 19
Views: 1,175
Posted By creyc

RE: first runaway

I take it a full-on braking didn't help much? I think that's a bit of a fault with these trucks, on a car the brakes are always strong enough to overcome the strength of the engine and at least slow...
Forum: Losi Monster Trucks
03-30-2005, 09:23 PM
Replies: 10
Views: 1,024
Posted By creyc

RE: #743 down for the count

That's cool that you have the cash to hire someone to fix it for you but remember this is a hobby not just a toy. You may wanna think about trying it yourself, and if you run out of patience or get...
Forum: Losi Monster Trucks
03-30-2005, 09:18 PM
Replies: 19
Views: 1,768
Posted By creyc

RE: Video: Engine Troubles

Thanks for the tips.

I'm going to buy a quart of anything else my hobby shop caries to test. I understand I should follow break in procedure with the new fuel and get fuel with the same nitro...
Forum: Losi Monster Trucks
03-29-2005, 10:20 PM
Replies: 19
Views: 1,768
Posted By creyc

RE: Video: Engine Troubles

With a lot of work I got it to stay running. The tuning was off but not by much and it just took an hour of turning 1/16th at a time till it would stay running. Still not much power, and no...
Forum: Digital Video (DV) & Video Editing Software
03-29-2005, 10:13 PM
Replies: 40
Views: 10,044
Posted By creyc

RE: Which video editing tool software you use ?

Ah, I must vouch for Vegas 5 as well since it is so overlooked in the world of consumer video editing. For its price, features and quality it is definitely a major player.
Forum: Losi Monster Trucks
03-29-2005, 10:10 PM
Replies: 10
Views: 778
Posted By creyc

RE: serial #

What size screws are these and is the a direct screw on this truck someplace that would fit? I'd like to order some from Horizon.
Forum: Losi Monster Trucks
03-29-2005, 10:07 PM
Replies: 16
Views: 942
Posted By creyc

RE: LST going loopy!

Any metal-on-metal contact can cause glitching. It's a common and well known about issue that exists on all RC vehicles. The glitching experienced on this truck is at its worst when you are running...
Forum: Losi Monster Trucks
03-29-2005, 01:46 AM
Replies: 61
Views: 4,063
Posted By creyc

RE: Diff Replacement...Skill Level?

Ah, I had to double check by testing on my truck this afternoon and I simply pull a kingpin for one of the A-arms allowing you plenty of room to pull the diff out. I find it easier to remove and...
Forum: Losi Monster Trucks
03-29-2005, 01:30 AM
Replies: 12
Views: 807
Posted By creyc

RE: Problems with the mach

Send it to Horizon. They'll look at it, attribute the issue as normal for the engine and send it back a few weeks later. Then go drop in something else, I've had it with the mach and it's too bad...
Forum: Losi Monster Trucks
03-29-2005, 01:13 AM
Replies: 10
Views: 778
Posted By creyc

RE: serial #

I would take the time to remove the backplate from the engine and look inside rather than just going by the manufacturing number. It's not worth the 10 minutes of hassle it takes to check inside.
Forum: Digital Video (DV) & Video Editing Software
03-29-2005, 12:27 AM
Replies: 19
Views: 2,974
Posted By creyc

RE: Need help from the video posting experts

SDCrashmaster, try Discreet Cleaner 6. Available right for your macintosh and will do just that task, among a few hundred others of course.
Forum: Digital Video (DV) & Video Editing Software
03-29-2005, 12:24 AM
Replies: 6
Views: 1,828
Posted By creyc

RE: Need Opinions - PCI or USB Capture?

I advise against both, unless you are looking at a high end PCI board such as a Matrox RT, etc.

Your best bet is to go along the firewire route. This means getting an external device that...
Forum: Digital Video (DV) & Video Editing Software
03-29-2005, 12:12 AM
Replies: 40
Views: 10,044
Posted By creyc

RE: Which video editing tool software you use ?

I use Apple Final Cut Pro for all my editing on my mac, and where I can't use FCP (on a PC) I use Avid Express Pro.

Now, would I recommend these programs to use? Na prolly not unless you're...
Forum: Losi Monster Trucks
03-28-2005, 11:53 PM
Replies: 21
Views: 1,720
Posted By creyc

RE: Everything messed up on LST

I took my LST up into the mountains of California a while ago and noticed a few things about this truck. For one thing, tuning is super critical to a properly running truck. I already knew it was...
Forum: Losi Monster Trucks
03-28-2005, 07:42 PM
Replies: 5
Views: 610
Posted By creyc

RE: Anyone breaking CVDs?

Yay, I get to spend an extra $72 to get a truck that performs as it should stock. I love being an early adopter. :|

The Losi way...
Forum: Losi Monster Trucks
03-28-2005, 01:08 AM
Replies: 61
Views: 4,063
Posted By creyc

RE: Diff Replacement...Skill Level?

there's no need to take off the shocks when doing the front...or at least I never had issues.
Forum: Losi Monster Trucks
03-28-2005, 01:06 AM
Replies: 19
Views: 1,154
Posted By creyc

RE: LST flooding

lol, stationary. Yea that's the correct way to do it. If only my lame RC shop would open up to the world of nitro more...
Forum: Losi Monster Trucks
03-28-2005, 01:04 AM
Replies: 73
Views: 5,391
Posted By creyc

RE: KILLER HOBBIES

I just wish they carried a larger variety of parts or I'd cancel my order with Horizon right now.
Forum: RC Painting, Detailing & Bodies
03-27-2005, 10:49 PM
Replies: 3
Views: 1,045
Posted By creyc

RE: Subaru WRX body on TC3: body posts too short!

Yep, nearly on the roof. I think the holes are actually in the middle of the rear window.
Forum: Losi Monster Trucks
03-27-2005, 10:19 PM
Replies: 5
Views: 610
Posted By creyc

Anyone breaking CVDs?

I was out in the mountains of California recently and broke a right rear CVD shaft right at the point it notches off for the pin at the wheel side. It happened over quite smooth terrain and the...
Forum: Losi Monster Trucks
03-27-2005, 10:10 PM
Replies: 19
Views: 1,154
Posted By creyc

RE: LST flooding

To those having flooding issues after shutting the engine off; always remember to bring a spring type paper clasp with you to clamp off the fuel line before shutting off the engine....
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.