RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: 70 ragtop
Showing results 1 to 25 of 500
Search took 0.86 seconds.
Forum: RC Warbirds and Warplanes
11-12-2021, 07:31 PM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

122" ARF, who's going to be first to get one in...

122" ARF, who's going to be first to get one in the states and stick a pair of Kolms in it :)

https://kingtechturbine.lu/JMB-Lockheed-P-38-Lightning_2
Forum: Marketplace
10-23-2021, 07:22 PM
Replies: 1
Views: 581
Posted By 70 ragtop

I'll take them, PM sent

I'll take them, PM sent
Forum: Marketplace
10-16-2021, 09:09 AM
Replies: 4
Views: 1,079
Posted By 70 ragtop

Thanks for the interest, sold to Ken Just...

Thanks for the interest, sold to Ken

Just need to figure out how to close the ad
Forum: Marketplace
10-15-2021, 05:23 PM
Replies: 4
Views: 1,079
Posted By 70 ragtop

Robart/Ziroli P-38 kit NIB

Robart P-38 kit with Robart gear. Kit and gear are new and untouched, most items still wrapped in original 1999 newspaper from Robart. Tires, spinners, mufflers and props look used. I'm a huge P-38...
Forum: Marketplace
09-13-2021, 10:12 AM
Replies: 1
Views: 786
Posted By 70 ragtop

F-18

PM sent
Forum: RC Warbirds and Warplanes
04-01-2021, 06:30 PM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

I haven't built a Ziroli yet, but 645s would be...

I haven't built a Ziroli yet, but 645s would be my choice ( with two on elevator). As far as doors actuators, if it were my project, I would do air retracts with air cylinders on the doors with a UP3...
Forum: RC Warbirds and Warplanes
03-21-2021, 10:41 AM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

No worries, happy to share I flew many...

No worries, happy to share

I flew many flights with the Tacon 160s and Vario props in the 36+ pound Yellow P-38. If flew very well with that setup, but it’s not super efficient. The RPM is too...
Forum: RC Warbirds and Warplanes
03-17-2021, 06:30 PM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

Hello I used the same Ramoser 16D light hubs...

Hello
I used the same Ramoser 16D light hubs for both 17.9 and 19.9" blades. The blades 456-16 and 456-16-L for the 17.9" and 505-16 and 505-16-L for the 19.9".
The Scorpians have a long shaft...
Forum: RC Warbirds and Warplanes
01-18-2021, 08:43 PM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

Hi Mark Right now it's flying with Scorpion...

Hi Mark

Right now it's flying with Scorpion SII-5535-190KV and Vario 19.9" adjustable pitch props. ESCs are Castle Edge 120s Gens Ace 5300 with 10 cells per side (10S). These are 5-6 years old...
Forum: RC Warbirds and Warplanes
01-13-2021, 08:43 PM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

Good to see some life here again, and some great...

Good to see some life here again, and some great looking projects
For those asking to join, if you love the P-38 ( or even if you just like it), consider yourself a member!

I've got a few twin...
Forum: RC Jets
06-30-2020, 09:45 AM
Replies: 255
Views: 69,823
Posted By 70 ragtop

Looks great, impressive build!

Looks great, impressive build!
Forum: RC Warbirds and Warplanes
06-21-2020, 07:43 PM
Replies: 66
Views: 21,618
Posted By 70 ragtop

Went to Tower to order EMS unassembled connectors...

Went to Tower to order EMS unassembled connectors and no longer stock it. Googled EMS and they must be out of business because no one had them.

Build is looking good!
Hansen Hobbies should have...
Forum: RC Jets
04-29-2020, 11:21 AM
Replies: 321
Views: 60,449
Posted By 70 ragtop

Look great, thanks for sharing! Have you been...

Look great, thanks for sharing!
Have you been able to fine clear pictures of the seat placards, in particular the one on the left side? I have an okay pictures I was going to post, but uploading...
Forum: RC Warbirds and Warplanes
01-25-2020, 04:51 PM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

Here you go, hope these help

Here you go, hope these help
Forum: Marketplace
01-08-2020, 08:54 PM
Replies: 5
Views: 610
Posted By 70 ragtop

Glad he was able to help you out !

Glad he was able to help you out !
Forum: Marketplace
01-07-2020, 04:53 PM
Replies: 5
Views: 610
Posted By 70 ragtop

Try emailing Jason at Funkey ...

Try emailing Jason at Funkey
[email protected]
Forum: RC Jets
12-14-2019, 08:36 AM
Replies: 18
Views: 2,873
Posted By 70 ragtop

VicRC ( https://www.vicrc.com/ ) has all the...

VicRC ( https://www.vicrc.com/ ) has all the molds for the Cook F-4. He was nice enough to pull a couple of new canopies for me, and we had Eureka RC ( Eureka Aircraft Company...
Forum: RC Warbirds and Warplanes
12-01-2019, 10:06 AM
Replies: 1,224
Views: 295,163
Posted By 70 ragtop

I little bigger, than measurements given, but if...

I little bigger, than measurements given, but if okay with the size, checkout Vic RC glass fuse? Looks like a really good start, and reportedly a great flying plane
Forum: RC Warbirds and Warplanes
09-30-2019, 08:12 PM
Replies: 113
Views: 62,941
Posted By 70 ragtop

Looks great!

Looks great!
Forum: Crash & Rebuild
05-21-2019, 07:42 PM
Replies: 25
Views: 8,206
Posted By 70 ragtop

Looking good! Like it never even happened:)

Looking good! Like it never even happened:)
Forum: RC Warbirds and Warplanes
05-14-2019, 12:00 PM
Replies: 1,588
Views: 374,923
Posted By 70 ragtop

Looks fantastic! Haven't been over the...

Looks fantastic! Haven't been over the RCScalebuilder to check on progress in a while, looks like I missed a lot. Well done!
Forum: Marketplace
02-16-2019, 04:56 PM
Replies: 12
Views: 1,375
Posted By 70 ragtop

If you're going to run an auction, put it on...

If you're going to run an auction, put it on Feebay, this isn't the place for it. I saw this last night, and I would pick it up, but the first guy already said he would take it. Surprised to see it...
Forum: RC Jets
10-16-2018, 06:53 PM
Replies: 978
Views: 199,974
Posted By 70 ragtop

Great thread, enjoying following along! I used...

Great thread, enjoying following along! I used the same method on the removable nose cone on my Yellow F-18, but used K&S tubing vs carbon.
The carbon should do the trick on the doors. Can also try...
Forum: RC Warbirds and Warplanes
10-10-2018, 08:01 AM
Replies: 433
Views: 78,138
Posted By 70 ragtop

The clips mentioned will work, I think they are...

The clips mentioned will work, I think they are metric. I actually put brass tubes and 4-40 hardware in mine. Makes it easy adjust to keep the joints tight, but not tight enough to bind. If you go...
Forum: RC Warbirds and Warplanes
10-06-2018, 04:34 PM
Replies: 113
Views: 62,941
Posted By 70 ragtop

Great progress, looking good!

Great progress, looking good!
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.