RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: trashbug
Showing results 1 to 9 of 9
Search took 0.65 seconds.
Forum: Kit Building
01-07-2015, 09:23 AM
Replies: 2,542
Views: 447,063
Posted By trashbug

You are approved!

You are approved!
Forum: Tips & Techniques
01-05-2015, 02:53 AM
Replies: 2
Views: 1,420
Posted By trashbug

I've had good luck with a vertical hot wire...

I've had good luck with a vertical hot wire cutter set up on a base/table like a jig saw. NO dust~) Keep the wire heat down so it doesn't burn or your template.
Forum: Kit Building
01-05-2015, 02:06 AM
Replies: 2,542
Views: 447,063
Posted By trashbug

All I can add is "excellent"!

All I can add is "excellent"!
Forum: Kit Building
01-04-2015, 08:45 AM
Replies: 2,542
Views: 447,063
Posted By trashbug

Please subscribe me to this thread. Thanks, ...

Please subscribe me to this thread.

Thanks,
JIm
Forum: Brushed/Brushless motors, speed controls, gear drives
02-07-2008, 07:14 AM
Replies: 5
Views: 3,075
Posted By trashbug

RE: Dynam esc Programming Problem

I received a Jeti Programming card and tested its operation with this Dynam ESC. It works great in all functions. Now I can reprogram the Battery Type and Hi/Low Cutoff Voltages back to NiCd if I...
Forum: Brushed/Brushless motors, speed controls, gear drives
02-05-2008, 08:40 AM
Replies: 5
Views: 3,075
Posted By trashbug

RE: Dynam esc Programming Problem

Here’s what the attached chart shows. The start voltage is the common start point for each voltage checked.

Cutoff V1 is the low voltage cutoff point using the stock controller right out of...
Forum: Brushed/Brushless motors, speed controls, gear drives
01-31-2008, 10:15 PM
Replies: 5
Views: 3,075
Posted By trashbug

RE: Dynam esc Programming Problem

My results after using the Dynam Programming Card show the following results:

I used a digital variable dc power supply. The cutoff voltages are absolutely consistent.

Starting Voltage ...
Forum: Brushed/Brushless motors, speed controls, gear drives
01-30-2008, 06:08 PM
Replies: 5
Views: 3,075
Posted By trashbug

RE: Dynam esc Programming Problem

I also have TP esc's and the beep pattern is very different. I'm hesitant to plug the Dynam Programming card into a TP esc since the result could be smoke. I'll try to plug a nicad pack into the...
Forum: Brushed/Brushless motors, speed controls, gear drives
01-30-2008, 04:29 PM
Replies: 5
Views: 3,075
Posted By trashbug

Dynam esc Programming Problem

Does anyone know how to change from nicad to lipo mode and adjust the low voltage cutoff points for different battery types using just the transmitter?

I have a Dynam 30 amp brushless esc and a...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.