RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: MadVenomm
Showing results 1 to 25 of 30
Search took 0.57 seconds.
Forum: Traxxas Monster Truck forum
06-27-2006, 09:53 AM
Replies: 25
Views: 12,046
Posted By MadVenomm

T-Maxx Exhaust Upgrade

What is best exhaust upgrage for the T-Maxx 3.3? The original pipe plastic baffle melted which caused major flooding..... Thanx to Jato Thriller.......
Forum: Traxxas Monster Truck forum
06-25-2006, 09:31 PM
Replies: 9
Views: 3,287
Posted By MadVenomm

RE: TMAXX 3.3 Smoking Glow Plugs

Sounds close to the same problem that I'm having, just not blowing glow plugs. The engine floods out with the slightest bit of throttle. What pipe do you recommend? Funny, the truck will continue to...
Forum: Traxxas Monster Truck forum
06-17-2006, 08:37 PM
Replies: 1
Views: 359
Posted By MadVenomm

T-Maxx 3.3

I need some serious help. I was racing a Raptor30 a few weeks ago and the truck performed awesome. As I was returning from a race it cut off and now it only idles. If I give it throttle it will bogg...
Forum: Traxxas Monster Truck forum
04-15-2006, 02:11 PM
Replies: 5
Views: 500
Posted By MadVenomm

RE: T-maxx 3.3. Fuel?!?!?!

I own a T-Maxx 3.3, has anyone tried 30%? Also, what's difference in reference to heli fuel besides higher oil content? Yes, I'm a heli-pilot getting grounded.
Forum: Traxxas Monster Truck forum
04-15-2006, 02:04 PM
Replies: 1
Views: 441
Posted By MadVenomm

RE: 3.3 T Maxx-Have they improved flaws of the 2.5s of the past?

This is my first Nitro truck and this thing is a beast, but I'm constantly doing repairs. Any suggestion to upgrades. I've installed alum. bulkheads, upper control arm, spur gear, and I need two...
Forum: Traxxas Monster Truck forum
04-15-2006, 01:52 PM
Replies: 36
Views: 4,450
Posted By MadVenomm

RE: Tmaxx 3.3 Project - Updating Photos

Purchased a T-Maxx 3.3 and the truck literally rips. It rips the parts clean-out. Everytime I run this truck it tears loose a part or two.
Spur, tires, bulkheads, suspension pins, and now the rear...
Forum: Traxxas Monster Truck forum
03-20-2006, 04:16 PM
Replies: 15
Views: 8,435
Posted By MadVenomm

RE: Just got the new T maxx 3.3

I live in Illinois and I'm having a hard time getting this thing hold a tune. At first it wouldn't think of pulling a wheelie, so I put a OS LC3 glowplug in and it ran very hot. Then I riched the...
Forum: Traxxas Monster Truck forum
03-07-2006, 05:38 PM
Replies: 226
Views: 24,408
Posted By MadVenomm

RE: T-MAXX 3.3

Just purchased the Jato 2.5R and the T-Maxx 3.3R, both are still in the box. I've just grounded my Heli and want to see what the ground pounders have to offer. I could use some help with break-ins...
Forum: Car Nitro & Gas Engines
03-06-2006, 05:35 PM
Replies: 0
Views: 314
Posted By MadVenomm

Newbie

I just purchase a Jato 2.5 and a T-Maxx 3.3. Need input to setup and tuning for best performance, do's and don'ts. I'm a grounded heli pilot with a need for speed.........Thanx to all........
Forum: Kit Building
01-10-2006, 07:00 PM
Replies: 0
Views: 876
Posted By MadVenomm

Top Gun Interceptor

I purchased a Topgun Interceptor ducted fan plane and I need to find the manufacturer for instructions, canopy, intake ducting, and etc. to finish the build. If anyone has any information it would be...
Forum: Batteries & Chargers
11-11-2005, 11:18 AM
Replies: 6
Views: 741
Posted By MadVenomm

RE: Charging Rates

Okay, this may sound crazy but what is C/5 and 2C?
Forum: Batteries & Chargers
11-10-2005, 03:05 PM
Replies: 6
Views: 741
Posted By MadVenomm

Charging Rates

Just purchased a Super Brain Pro969 and sent back for upgrade. The directions are pretty lame on charging rates for NiMh and NiCd, can someone with experience give me feedback on charge setup for...
Forum: Batteries & Chargers
11-10-2005, 02:55 PM
Replies: 28
Views: 3,502
Posted By MadVenomm

RE: What charger would you recommend?

What calculations do you use to set the charging rates? I have the 969 and directions don't seem to charge the batteries all that well.
Forum: RC Helicopter General Discussions
11-04-2005, 10:32 PM
Replies: 14
Views: 890
Posted By MadVenomm

RE: Flybar location

Have any of you removed your paddles? If so, what was the response of your heli?
Forum: Scale RC Helicopters
11-04-2005, 07:50 AM
Replies: 31
Views: 5,699
Posted By MadVenomm

RE: Weigh in on Scale!

I saved this heli in flight as my desktop background. Where did you purchase this kit? I must have one.......
Forum: RC Helicopter General Discussions
11-04-2005, 07:46 AM
Replies: 14
Views: 890
Posted By MadVenomm

Flybar location

What is difference in having the flybar/paddles above the main blades to having the flybar/paddles below the main blades?
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
04-17-2005, 11:53 AM
Replies: 1
Views: 375
Posted By MadVenomm

RX Battery Connections

Has anyone used two RX batteries in parallel to extend their flight-time and lessen the battery drain?
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-21-2005, 09:01 AM
Replies: 16
Views: 1,272
Posted By MadVenomm

RE: Raptor stating trouble. Engine shaft wont turn

Barracudahockey is correct, I had the same problem with my raptor 60. After a couple of turns, it seemed to lockup wouldn't turn. The trust washer would cause the fan too loosen up and drive the...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-14-2005, 07:41 AM
Replies: 3
Views: 610
Posted By MadVenomm

RE: 90 Conversion

Thanx....... for all the help!!!!!!!!!
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
02-11-2005, 07:24 AM
Replies: 3
Views: 610
Posted By MadVenomm

90 Conversion

My buddy just bought the 90 upgrade raptor kit. There is black ring in the kit (washer type) and he doesn't know where it goes or it's use. If anyone has upgraded their rappy 60 to a 90, please give...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
12-05-2004, 12:33 AM
Replies: 6
Views: 910
Posted By MadVenomm

RE: Rear Servo Mounting..

I really appreciate the feedback. I think I'll leave it as is. Besides, I just crash two weeks ago, it would have damaged the servo. Thanx........
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
12-04-2004, 02:40 AM
Replies: 6
Views: 910
Posted By MadVenomm

Rear Servo Mounting..

Is there a big advantage to mounting the servo on the tail? If so, what?
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
11-18-2004, 12:59 PM
Replies: 1
Views: 593
Posted By MadVenomm

Crash!!!!!!!!!

Will a os 90 fit the raptor 70?
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
11-04-2004, 07:55 AM
Replies: 1
Views: 609
Posted By MadVenomm

Tuning OS 70

I have the OS 70 and it seems to running rich. It has about 10 tanks through it so far and they're is fuel dripping from the exhaust. It has the Hatori 2-Piece muffler. Will this clear up once I'm...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
11-03-2004, 03:40 PM
Replies: 2
Views: 514
Posted By MadVenomm

Glow Plugs

I have the OS 70 engine in the raptor 60 and for some strang reason, it burns up the glow plug. Is their an alternative plug to the #8?
Showing results 1 to 25 of 30
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.