RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: NEW222
Showing results 1 to 25 of 358
Search took 0.64 seconds.
03-18-2020, 03:18 PM
Replies: 924
Views: 235,304
Posted By NEW222

Yep. Seeing this made me realize yet again that...

Yep. Seeing this made me realize yet again that mine is still not yet finished...... Was going to use a Medallion .049, then said nope and off to e-power. Well, it has gotten a bit closer to being...
Forum: Glow Engines
03-18-2020, 03:13 PM
Replies: 8
Views: 1,080
Posted By NEW222

I know it would take some time, but after your...

I know it would take some time, but after your nitro fuel bath, I would give each a little running time before putting away.
Forum: Control Lines
03-18-2020, 03:09 PM
Replies: 6
Views: 3,880
Posted By NEW222

Yep. Doculam lightweight and cheap. Can use a...

Yep. Doculam lightweight and cheap. Can use a light spray of paint on the underside befor applying, and or scuff teh outside up and paint it once applied.
Forum: Glow Engines
02-13-2019, 08:30 PM
Replies: 5,192
Views: 560,486
Posted By NEW222

All good now. Got it figured out. Thank you.

All good now. Got it figured out. Thank you.
Forum: Glow Engines
02-11-2019, 08:47 PM
Replies: 5,192
Views: 560,486
Posted By NEW222

Hi. I recently acquired an old Fox .15x control...

Hi. I recently acquired an old Fox .15x control line engine with an inherent problem. It came to me second hand with the wrist pin sticking out front of the piston. I was able to carefully squeeze it...
Forum: Glow Engines
09-10-2018, 09:30 PM
Replies: 2,977
Views: 477,235
Posted By NEW222

Great, thank you for the replies.

Great, thank you for the replies.
Forum: Glow Engines
09-10-2018, 07:35 PM
Replies: 2,977
Views: 477,235
Posted By NEW222

Just a quick little Enya question for those here...

Just a quick little Enya question for those here regarding an Enya engine of mine. I acquired an old Enya .09 III control line engine. This is the one with the opposite side exhaust. Anyways, when I...
09-23-2017, 03:47 PM
Replies: 1
Views: 465
Posted By NEW222

message me your e-mail address. You might be...

message me your e-mail address. You might be happy!
09-10-2017, 11:22 AM
Replies: 2
Views: 1,982
Posted By NEW222

Cool video. Thanks.

Cool video. Thanks.
Forum: RC Airboats
07-03-2017, 04:27 PM
Replies: 7
Views: 2,150
Posted By NEW222

Thank you. That sounds about what I have for...

Thank you. That sounds about what I have for movement then. I will just have to fix her up and get it wet to find out for sure though. Two weeks.....
Forum: RC Airboats
07-03-2017, 02:58 PM
Replies: 7
Views: 2,150
Posted By NEW222

If I may ask, do you happen to have a 'suggested'...

If I may ask, do you happen to have a 'suggested' amount of travel for the rudders? I am sure they will all be different based on design, but is there a starting point. The reason for enlarging them...
Forum: RC Airboats
07-02-2017, 06:17 PM
Replies: 7
Views: 2,150
Posted By NEW222

Airboat Woes....

So last week while on holidays, I had the pleasure of playing around with my airboat. It had also had an engine upgrade from the finniky MDS 40 to an OS FSR 40!. Firstly this engine is a very nice...
Forum: RC Airboats
05-22-2017, 06:20 PM
Replies: 11
Views: 4,096
Posted By NEW222

If it's any consolation, after seeing your other...

If it's any consolation, after seeing your other builds, I dont think you will have a problem. I think your biggest problem will be painting it, cause I know how much you like the bare wood....
Forum: RC Airboats
05-18-2017, 05:27 PM
Replies: 11
Views: 4,096
Posted By NEW222

Have fun, and I'll be watching. Should be a very...

Have fun, and I'll be watching. Should be a very interesting build, especially as you mentioned with the limited information available. Good luck!
04-29-2017, 10:35 PM
Replies: 13
Views: 4,896
Posted By NEW222

Not a whole lot posted about the Sig Hummer, but...

Not a whole lot posted about the Sig Hummer, but it is a nice little plane, quick building, and easy to follow instructions. Cannot remark on flying as mine has been built for about 15 years already...
Forum: RC Airboats
04-26-2017, 06:32 PM
Replies: 206
Views: 14,570
Posted By NEW222

Personally, I would leave the washer. I have run...

Personally, I would leave the washer. I have run engines before without the washer, but would not recommend it as the washer spreads the load out over a bigger area than the nut.
Forum: The Clubhouse
04-26-2017, 06:26 PM
Replies: 185
Views: 13,878
Posted By NEW222

@IBJoel. I would also like to clarify one thing...

@IBJoel. I would also like to clarify one thing also for you to let the IT team know. The screenshot I and others had posted about the widescreen version of the forum only applies to me while...
Forum: The Clubhouse
04-24-2017, 03:55 PM
Replies: 185
Views: 13,878
Posted By NEW222

I looked again, and it does in fact appear to be...

I looked again, and it does in fact appear to be text. It would be text in both the 'Radios, batteries, Clubhouse And More', and 'RC Airplanes'. It is a very long thin line of all the subforms that...
Forum: RC Airboats
04-24-2017, 03:44 PM
Replies: 206
Views: 14,570
Posted By NEW222

Good job. Sounds like you're having fun. I had...

Good job. Sounds like you're having fun. I had mine out late last week in the yard on dry grass. It goes, but slowly, then like he$# when it gets going. It even got air while losing control, going...
04-24-2017, 03:41 PM
Replies: 11
Views: 2,568
Posted By NEW222

Doing fine here. Welcome back, we missed you!

Doing fine here. Welcome back, we missed you!
Forum: The Clubhouse
04-21-2017, 07:23 AM
Replies: 185
Views: 13,878
Posted By NEW222

Unless I am missing something, is there still an...

Unless I am missing something, is there still an option of 'My Subscribed Forum'? Before, I had a list of the topics I enjoyed reading, and now it appears that I have to scroll through each...
Forum: Beginners
04-17-2017, 10:07 PM
Replies: 3
Views: 1,090
Posted By NEW222

What kind of Tx did you buy?

What kind of Tx did you buy?
Forum: RC Airboats
04-11-2017, 09:38 AM
Replies: 4
Views: 2,930
Posted By NEW222

I cannot definitively answer your question, but...

I cannot definitively answer your question, but as a Lil' Swamp Buggy owner, I believe that most people flip the engine pylon around and run it in a standard tractor setup. Plus from what I have...
Forum: Beginners
04-10-2017, 08:11 PM
Replies: 5
Views: 816
Posted By NEW222

It seems like you have a lot on your mind here. I...

It seems like you have a lot on your mind here. I do agree it is changed quite a bit in the last 10 years. Electric is most definitely the quick, easy, and clean way to go now-a-day. Drones don't do...
Forum: RC Airboats
04-08-2017, 04:26 PM
Replies: 0
Views: 1,796
Posted By NEW222

.15 Size Airboat Plans

Hi there. So, I have a .15 rc plane engine here ready for a home, and would like to build an airboat for it. Only problem I have is I cannot find any downloadable plans for a .15 size airboat. If...
Showing results 1 to 25 of 358
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.