RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Sricketts
Showing results 1 to 18 of 18
Search took 0.58 seconds.
11-18-2005, 02:38 PM
Replies: 2
Views: 510
Posted By Sricketts

How do you add an additional servo to your radio?

Greetings,

I was wondering how one goes about adding an additional servo to an empty channel on a futaba 9U series radio system. I am planning to use the additional channel to for either pan or...
09-12-2005, 11:18 AM
Replies: 2
Views: 506
Posted By Sricketts

Mid-to-High RPM Vibration

I have a raptor 50, that i have recently repaired after a minor crash. However when i took the helicopter out to fine tune it yesterday, i observed a vibration at a little less than half throttle....
08-15-2005, 02:55 PM
Replies: 7
Views: 663
Posted By Sricketts

RE: Still having Main Blade Pitch Problems after crash

Firstly thanks again for the help.

Ok one at a time, -pkh-:

Okay, I don't think that it is that the blades are very negative to start, when everything is neutral (swashplate, flybar, and at...
08-15-2005, 10:34 AM
Replies: 7
Views: 663
Posted By Sricketts

RE: Still having Main Blade Pitch Problems after crash

The Problem is that when the helicopter is set in a neutral state (i.e. The swashplate and stabilzer bar,are level and neutral, and the collective at the lowest position) the rotor blades appear to...
08-12-2005, 11:15 AM
Replies: 7
Views: 663
Posted By Sricketts

Still having Main Blade Pitch Problems after crash

I posted a message about 2 weeks ago about a blade pitch problem that my helicopter developed after a small crash. After Replacing the Main blades, the Oval Stabilizer Bar control rods, and the...
08-04-2005, 02:01 PM
Replies: 4
Views: 788
Posted By Sricketts

RE: Help Needed: Raptor 50 Blade Pitch Problem after small crash

Thanks Guys, I will try both when i go home, actually now that u mention it, when i was replacing the oval stabilier bar contol rod, i had had tried to disassemble the rotor head to replace the oval...
08-04-2005, 10:08 AM
Replies: 4
Views: 788
Posted By Sricketts

Help Needed: Raptor 50 Blade Pitch Problem after small crash

I have rencently begun flying on a raptor 50, a few weeks ago i was flying the heli and crashed it. It was a minor crash, or so i thought at the time, the blades, the landing gear snapped and one of...
06-08-2005, 10:50 AM
Replies: 5
Views: 625
Posted By Sricketts

RE: Please Help - Engine Problems

Thanks baracudahockey,

You were right, it was the muffler that had come loose and must have been leaning the engine out like u had thought, i must admit i had been completely distruaght when it...
06-02-2005, 01:59 PM
Replies: 5
Views: 625
Posted By Sricketts

RE: Please Help - Engine Problems

barracudahockey,

i will check the muffler when i go home, the thought had crossed my mind that i could be the muffler, but would that explain the inability for the engine to go to idle?

...
06-02-2005, 11:09 AM
Replies: 5
Views: 625
Posted By Sricketts

Please Help - Engine Problems

Greetings,

I have recently bought a second hand heli from a member on RCU, its a raptor 30 converted to a 50, with a webra glow engine. I have set it up and have begun to train on it. I have...
05-24-2005, 03:57 PM
Replies: 4
Views: 942
Posted By Sricketts

RE: Help Needed: Difficulty Starting helicopter engine

Thanks 3D,

The motor is a webra .51.....

actually i had forgot to ask what the optimum throttle position for starting is.....i take it from your reply that idle is the correct position?
...
05-24-2005, 09:08 AM
Replies: 4
Views: 942
Posted By Sricketts

Help Needed: Difficulty Starting helicopter engine

Greetings,

I recently purchases a second-hand Raptor heli. This is my first glow engine vehicle, an i am having difficulty starting the engine. I have managed to get it started and running once,...
05-13-2005, 10:30 AM
Replies: 15
Views: 3,100
Posted By Sricketts

RE: Has anyone tried a system from wirelessvideocameras.com?

mklarich -

Could you perhaps recommend a set up from black widow that would give me the kind of range performance that i am looking for. what strength transmitter and what size/type of antennas...
05-12-2005, 09:50 AM
Replies: 15
Views: 3,100
Posted By Sricketts

RE: Has anyone tried a system from wirelessvideocameras.com?

thanksfor the imput so far guys.

mklarich - i haven't got an exact budget as yet, but i do know what the requirements of what i am looking for are: I want a real Time AP system, that can...
05-11-2005, 09:38 AM
Replies: 15
Views: 3,100
Posted By Sricketts

Has anyone tried a system from wirelessvideocameras.com?

Has anyone tried a transmitter/ receiver package from wirelessvideocameras.com? They have a number of packages that have various ranges all the way up to five miles, several of which require an...
09-23-2004, 11:17 AM
Replies: 18
Views: 2,881
Posted By Sricketts

RE: What are the load carrying abilities of your R/C heli?

again thanks for the input, keep it coming guys.

but wow, i guess a little clarification is needed, because y'all really getting paranoid, firstly I don't even live in the united states. The...
09-22-2004, 04:41 PM
Replies: 18
Views: 2,881
Posted By Sricketts

RE: What are the load carrying abilities of your R/C heli?

Why the hesitation?

I muss be missing something? Just Curious...

In any case i'm greatful for the information guys
09-22-2004, 11:01 AM
Replies: 18
Views: 2,881
Posted By Sricketts

What are the load carrying abilities of your R/C heli?

I'm new to world or R/C helis, i am in the process of shopping around for R/C Helicopter to buy. One of my overall goals with whatever heli i end up buying is to install some sort of in-flight video...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.