RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: doh2doh
Showing results 1 to 23 of 23
Search took 0.56 seconds.
11-02-2007, 08:15 AM
Replies: 2
Views: 619
Posted By doh2doh

RE: Wing Dragon II - It takes a lickin . . .

I have gone brushless and lipo with mine. It will climb at 45 degrees now. I have also covered all the wings with folafilm heat shrink film, makes them real strong and the colour scheme makes it much...
09-06-2007, 02:10 AM
Replies: 4
Views: 1,625
Posted By doh2doh

RE: Vulcan SE, no acceleration

They both came with the two speed transmition in when I purchased them.
I will try leaning out the bottom needle.
Thanks for your help.
08-30-2007, 04:29 AM
Replies: 4
Views: 1,625
Posted By doh2doh

Vulcan SE, no acceleration

I have just bought two Vulcan SE. Both of them have no acceleration. I need to give them a push to get them going, then they slowly pick up speed until I turn, then they virtualy stop.
Any Ideas...
06-21-2007, 10:10 AM
Replies: 2
Views: 720
Posted By doh2doh

RE: Imax B5 Charger

Have a look on the rcgroups.com site. There are a few posts about it on there. I am thinking of getting one myself.
03-27-2007, 03:22 AM
Replies: 6
Views: 852
Posted By doh2doh

RE: Which Plane?

You can buy the wilga direct from the manufacturer. Go to www.sapac.com.cn
If I were you I would opt for the upgraded colocation. It will probably cost about £75 including postage to the UK. You...
02-13-2007, 09:25 AM
Replies: 4
Views: 944
Posted By doh2doh

RE: Model Manufacturers from the Far East

Sapac can be found at www.sapac.com.cn
01-05-2007, 11:00 AM
Replies: 33
Views: 4,021
Posted By doh2doh

RE: cheap 4 channel pitts

I bought the version that raidentech sells. I orded it straight from the manufacturer.
It only costs $69.50 RTR for the brushed version or $86.50 for the brushless and Lipo version.
I paid an...
09-30-2006, 11:16 AM
Replies: 33
Views: 4,021
Posted By doh2doh

RE: cheap 4 channel pitts

I think you will find it is made by sapac. See www.sapac.com.cn
09-28-2006, 02:17 AM
Replies: 33
Views: 4,021
Posted By doh2doh

RE: cheap 4 channel pitts

I have seen these planes on hobbyjapan2000 and rc-expert web site and was thinking of getting one for my wife to learn with. Do you think it would be suitable for learning with?
What is the climb...
09-12-2006, 08:11 AM
Replies: 5
Views: 1,085
Posted By doh2doh

RE: Parkflyers Extra 330L

I have also been looking for info on this plane. I can only find two people on this forum that have it. If you do a search on the rcgroups forum there is more info there.
From what I have read it...
09-12-2006, 02:12 AM
Replies: 5
Views: 1,228
Posted By doh2doh

RE: Wing Dragon 3Ch Brushless conversion

Search on rcgroups forum. A number of people have done it on there using a BP12 motor. One guy has even put a camera on it. They say the performance is great, even with the orriginal battery.
Let...
09-10-2006, 10:14 AM
Replies: 4
Views: 985
Posted By doh2doh

Anyone flown parkflyers Extra 330l?

Has anyone had a go with a parkflyers extra 330l?
What do they fly like.
Would this be a good step up from my wing dragon sportster (beginair) or would I be better off buying pakrflyers edge 540?
09-02-2006, 11:22 AM
Replies: 3
Views: 432
Posted By doh2doh

RE: wingdragon losing power

The batteries I am using are Ni-MH 9.6v and 8.4v.
They have both been used about 20 times. They get warm when charging but never hot. They do get very hot when in the plane.
The motor is an...
09-01-2006, 10:19 AM
Replies: 3
Views: 432
Posted By doh2doh

wingdragon losing power

Hi.
I am having problems with my wing dragon. It just dosent have the power it use to have, so it hardly climbs at all.
I have tryed a new motor and am using a peak charger on the batteries.
...
Forum: CEN Racing
05-16-2006, 02:11 AM
Replies: 5
Views: 570
Posted By doh2doh

RE: Genesis veering right

Thanks for all the help everyone. Just need it to stop raining now to try out some of these ideas.
Forum: CEN Racing
05-15-2006, 08:28 AM
Replies: 5
Views: 570
Posted By doh2doh

RE: Genesis veering right

Thanks for that dustin. I will give some of these ideas a try.
Forum: CEN Racing
05-15-2006, 02:10 AM
Replies: 5
Views: 570
Posted By doh2doh

Genesis veering right

I have just purchased a Genesis and am having problems with it veering right under acceleration.
When it is going at a constant speed or slowing down it runs straight but under acceleration it goes...
11-08-2005, 10:19 AM
Replies: 8
Views: 1,061
Posted By doh2doh

RE: Wing Dragon main wing needed

I used centuryuk.co.uk. They had a list of dealers in the UK that they supply to. I gave a few of them a ring and got one orded that is near enough for me to pick up from the shop. Couldn't have...
11-07-2005, 03:08 AM
Replies: 8
Views: 1,061
Posted By doh2doh

RE: Wing Dragon main wing needed

Thanks for your help everyone.
I have managed to order a new wing now.
11-03-2005, 11:13 AM
Replies: 8
Views: 1,061
Posted By doh2doh

Wing Dragon main wing needed

Can anyone tell me of where I can buy a main wing for the wing dragon 3 channel?
Every where I look sells the 4ch wing but not the 3ch, or they don't deliver to the UK.
Anyone know of some good...
03-30-2005, 04:50 AM
Replies: 2
Views: 466
Posted By doh2doh

Tail boom help

I have just splintered the tail boom on my honey bee v1.
Instead of waiting for a new one from China I have got some carbon fibre from the local hobby shop.
The problem is I am not sure how...
11-06-2004, 07:12 AM
Replies: 0
Views: 361
Posted By doh2doh

Honeybee2 FP

I am thinking of buying a Honeybee 2 FP but have a few questions I hope someone can answer.

1. Will it work with FMS using a parrallel cable and windows XP?

2. Is it as strong as the...
10-07-2004, 09:32 AM
Replies: 4
Views: 687
Posted By doh2doh

fixed or collective pitch?

I am looking at buying my first helicopter. I am thinkink of going for the Esky Honey Bee but was unsure wether to go for the fixed or collective pitch model? Whitch will be the easiest to learn...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.