RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: roylab
Showing results 1 to 25 of 56
Search took 0.64 seconds.
Forum: Marketplace
12-12-2019, 10:30 AM
Replies: 2
Views: 1,079
Posted By roylab

Hog Bipe

Hi Ivan, what is the plane covered with?
Forum: Marketplace
11-18-2018, 04:02 PM
Replies: 1
Views: 348
Posted By roylab

Check your PM's

Check your PM's
Forum: RC Jets
03-14-2015, 08:23 AM
Replies: 58
Views: 4,037
Posted By roylab

Me Too. Invoiced for something bought & paid for...

Me Too. Invoiced for something bought & paid for with Paypal about 1 1/2 years ago.
Forum: Questions and Answers
03-10-2015, 10:10 AM
Replies: 45
Views: 3,949
Posted By roylab

A cap full or more of automotive octane booster...

A cap full or more of automotive octane booster in a gallon of Coleman fuel solves the problem of low octane.
Forum: RC Warbirds and Warplanes
10-05-2014, 05:42 AM
Replies: 52
Views: 16,934
Posted By roylab

What is wing loading?

What is wing loading?
Forum: JR Radio & Spektrum Radios
06-12-2014, 07:12 AM
Replies: 0
Views: 354
Posted By roylab

Module from 11x zero compatible w/xp9303

Will a module from an 11X zero work in a XP9303 & how?
Forum: Gas Engines
03-13-2014, 02:39 PM
Replies: 3
Views: 3,514
Posted By roylab

That's the only difference? I was under the...

That's the only difference? I was under the impression that the carb & ignition was upgraded because of the problems in tuning but do not know for sure. Any other info out there?
Forum: Gas Engines
03-13-2014, 06:22 AM
Replies: 3
Views: 3,514
Posted By roylab

Saito FG-36 vs FG-36B

Anybody know the differences between these two engines. I have read about the numerous problems with the FG-36. Have the problems been solved with the FG-36B. Also both of these engines have been...
Forum: RC Warbirds and Warplanes
03-01-2014, 07:19 AM
Replies: 1,805
Views: 450,719
Posted By roylab

Nice job with the panel lines. How did you do...

Nice job with the panel lines. How did you do them?
Forum: Airtronics Support Forum
12-16-2011, 01:58 PM
Replies: 2
Views: 1,348
Posted By roylab

RE: SD-10G Issue With TX Battery Voltage

I had the same problem after RF upgrade. Removed pack & tested with a load on it & battery made a big drop. It had a bad cell. Replaced with a 2000mah Eneloop NMH & it's ROCK STEADY.
Forum: JR Radio & Spektrum Radios
08-15-2011, 04:33 AM
Replies: 3
Views: 822
Posted By roylab

RE: JR 8103 FLAP PROGRAMMING

Top Flite 60 SIZE P-47
Jr rx 649
one aileron servo
throttle servo
two flap servos on flap & aux 2 channels
one rudder servo
one elevator servo

Would like to be controlled by three...
Forum: JR Radio & Spektrum Radios
08-15-2011, 03:46 AM
Replies: 3
Views: 822
Posted By roylab

JR 8103 FLAP PROGRAMMING

Can anyone help with step by step instructions for programming a JR 8103 for flaps using two servos PLEASE? I have spent all day trying to figure this out & it's driving me CRAZY.
Forum: Off Topic Forum - Cars, Trucks, Buggies and more
07-24-2011, 01:26 PM
Replies: 131
Views: 9,303
Posted By roylab

RE: Amy Winehouse Found Dead

Guys,

THis is a RADIO CONTROL MODEL WEBSITE! Take it to FACEBOOK or some other website!
Forum: Airtronics Support Forum
05-23-2011, 01:38 PM
Replies: 8
Views: 1,283
Posted By roylab

RE: SD10-G DISPLAY

So then I should not be concerned @ this time.

Thanks Mike!
Forum: Airtronics Support Forum
05-23-2011, 09:08 AM
Replies: 8
Views: 1,283
Posted By roylab

RE: SD10-G DISPLAY

I am not leaving it in the sun. This happens during pre-flight checkout & flying time of 10 -15 minutes. I then place TX out of direct sunlight.
Forum: Airtronics Support Forum
05-23-2011, 08:47 AM
Replies: 8
Views: 1,283
Posted By roylab

SD10-G DISPLAY

I noticed that the screen on my SD10-G Tx when in direct sunlight starts to darken @ each corner. Is this normal? It clears up when it is out of sunlight.
Is this impending screen failure?
Forum: Airtronics Support Forum
02-24-2011, 02:41 PM
Replies: 8
Views: 1,475
Posted By roylab

RE: SD10G BATTERY

Mike,

What about the voltage fluctuation.
I followed your instructions & these are the results. Charged battery with supplied wall wart. Turned on TX & got a reading of 8.1 - 7.9. After 20...
Forum: Airtronics Support Forum
02-24-2011, 06:43 AM
Replies: 8
Views: 1,475
Posted By roylab

RE: SD10G BATTERY

Hi Mike,

I followed your instructions & these are the results. Charged battery with supplied wall wart. Turned on TX & got a reading of 8.1 - 7.9. After 20 minutes "on" the reading was 7.7 - 7.5...
Forum: Airtronics Support Forum
02-17-2011, 03:40 PM
Replies: 8
Views: 1,475
Posted By roylab

SD10G BATTERY

Just got back my TX that was in for the RF modification. I charged the battery overnight using the Airtronics wall wart. After charge was complete I turned it on to check voltage & got a reading of...
Forum: Airtronics Support Forum
10-04-2010, 12:29 PM
Replies: 1
Views: 1,053
Posted By roylab

NEW 8 CHANNEL FHSS-3 RX

Just purchased (4) #92824 rx's FHSS-1 recently. Can these be converted to FHSS-3 technology in the future?
Forum: ARF or RTF
09-29-2010, 07:04 PM
Replies: 1,279
Views: 147,438
Posted By roylab

RE: Pacific Aeromodel Clipped Wing Monocoupe Build

Thanks for the info. How much for complete airframe?
Forum: ARF or RTF
09-29-2010, 08:07 AM
Replies: 1,279
Views: 147,438
Posted By roylab

RE: Pacific Aeromodel Clipped Wing Monocoupe Build

Can someone tell me how long a wing panel & aileron on the the Coupe. I have an extra set of wings for my KANGKE MONOCOUPE & would like to clip them.
Forum: Kit Building
06-07-2010, 11:44 AM
Replies: 75
Views: 50,461
Posted By roylab

RE: ID Kit ΒΌ Super Decathlon, need advice + rebuild start

Anyone out there have the pattern for the windshield?
Forum: Gas Engines
12-21-2008, 02:10 PM
Replies: 6
Views: 1,050
Posted By roylab

RE: RCS 140 ENGINE PROP NUT

Found one from Truturn 8mm x 1.25 thread for crank w/10mm od to fit into prop id w/10-32 thread other end for spinner. RCS 140 has a short shaft like MOKI 1.2.
Forum: Gas Engines
12-20-2008, 10:24 PM
Replies: 6
Views: 1,050
Posted By roylab

RE: RCS 140 ENGINE PROP NUT

RCS doesn't have any. Engine no longer handled by them.
Showing results 1 to 25 of 56
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.