RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: funshawstud
Showing results 1 to 25 of 120
Search took 0.63 seconds.
Forum: RC Flight Simulator Software
10-18-2005, 08:29 AM
Replies: 2
Views: 749
Posted By funshawstud

RE: real flight simulator

THANKS ALLOT !!!!
works good now
I will have to remeber that for the future
thanks again
mike
Forum: RC Flight Simulator Software
10-17-2005, 09:02 PM
Replies: 2
Views: 749
Posted By funshawstud

real flight simulator

I purchased a real flight simulator from a swap meet from this nice little old man ( first mistake ) simply to play with on rainy days etc.
I asked if it was an old copy and the guy said only a...
Forum: RC Giant Scale Cars
06-05-2005, 07:41 PM
Replies: 15
Views: 1,030
Posted By funshawstud

RE: There are no monsters,no real ones, but there are...

I had that email a while ago , the one I got showed what was left of the hiker as well
it ate him to the bone from the ankles to just above the waist and mauled around with what was left.
very...
Forum: RC Giant Scale Cars
05-08-2005, 05:15 AM
Replies: 9
Views: 920
Posted By funshawstud

RE: I need help with a spark plug issue

I had the same problem when I first got mine
I swtched to coleman and now have not had the original plug out in months ( same ratios and needle settings ) try it you will like it.
Mike
Forum: RC Giant Scale Cars
04-18-2005, 07:57 PM
Replies: 15
Views: 913
Posted By funshawstud

RE: New Vid lots off jumping MT,MArder and LB

very cool !
I have a lame unrleated question
What are the giant structures in the back ground used for they look just masive ?
Mike
Forum: RC Giant Scale Cars
04-17-2005, 06:16 PM
Replies: 13
Views: 5,298
Posted By funshawstud

RE: why do i keep burning up steering servos?

you may have an internal reciever short causing problems with ploarity in you servo.
had it happen a long time ago in a small battery car cased by dirt/moisture on the reciever board
just a...
Forum: RC Giant Scale Cars
04-12-2005, 01:29 AM
Replies: 32
Views: 1,962
Posted By funshawstud

RE: Steering Servo - what do you use?

I use the stock servo , just keep a few sets of replacement gears @ 4.00 an entire set.
pain in the but to have to replace them ( easy to replace ) I just figure that it will be hard to find a...
Forum: RC Giant Scale Cars
04-11-2005, 05:11 AM
Replies: 22
Views: 966
Posted By funshawstud

RE: 1/5 + Sand?

there is a thread on here somewere with a bunch of killer vids of marders etc it would give you a good idea of what to expect.
forgot to upload a pic last time
kinda plane still need to get out...
Forum: RC Giant Scale Cars
04-10-2005, 07:27 PM
Replies: 22
Views: 966
Posted By funshawstud

RE: 1/5 + Sand?

avery
just a note to save ya some frustration
ya need to get adapters for the tmaxx size tires to fit on the FH.
If you want to be on sand the stock tires will almost certainly just dig a hole....
Forum: RC Giant Scale Cars
04-10-2005, 01:22 PM
Replies: 76
Views: 5,172
Posted By funshawstud

RE: Does anyone use camping fuel??

ya that is really killer and it looks good to very well put together !
Forum: Questions and Answers
04-09-2005, 03:13 PM
Replies: 3
Views: 518
Posted By funshawstud

monokote question

I have covered many planes to this point and for my latest one ( senior telemaster ) I decided to use insignia blue.
For some reason the glue were the coating seems has leached out as I moved the...
Forum: RC Giant Scale Cars
04-09-2005, 06:06 AM
Replies: 76
Views: 5,172
Posted By funshawstud

RE: Does anyone use camping fuel??

it works better than gas mix the same ratios as you were for gas.
small needle change in my case and in my opinion better performance.
havent used gas in months and to this day have the original...
Forum: RC Giant Scale Cars
04-06-2005, 05:25 PM
Replies: 14
Views: 709
Posted By funshawstud

RE: Tapping

best way to deal with stainless
RAZOR sharp tooling only and coolant while machning.
As far as taps you may go through a tap a hole at times. I have only ever used regular tapping fluid and I...
Forum: RC Giant Scale Cars
04-05-2005, 04:05 PM
Replies: 9
Views: 643
Posted By funshawstud

RE: what happened?

your gears are stripped inside the servo ( almost gauranty it )
take the screws out of the bottom of the servo check the gears and order new ones
( just happened to me from a gental nudge into a...
Forum: RC Giant Scale Cars
04-05-2005, 01:18 AM
Replies: 18
Views: 870
Posted By funshawstud

RE: MT tire problems

lightly rough the surfaces with sand paper
then make sure everything is spotlessly clean I used rubbing alchohol.
I assembled them and warmed them up ( just put them on my heat vent for a while )...
Forum: RC Giant Scale Cars
04-03-2005, 07:54 PM
Replies: 11
Views: 699
Posted By funshawstud

RE: mistaking throttle for brake

unrelated issue but also funny
sounds like the thing that happened to me while flying inverted 8 ft off the ground wide open.
HMM I swore up was back on the right stick , O ya that was while...
Forum: RC Giant Scale Cars
04-03-2005, 02:09 PM
Replies: 2
Views: 462
Posted By funshawstud

RE: Stock Tires and wheels

try ebay many people put monster tires on and sell the stocks
Forum: RC Giant Scale Cars
04-03-2005, 02:02 PM
Replies: 57
Views: 3,209
Posted By funshawstud

RE: FG or not to FG?

my TMAXX is just as durable as my 1/5th if not more durable.
nitros weigh allot less
I would advise you keep saving and go with a 1/5th scale gasser. Allot less fussy in the engine dept and allot...
Forum: RC Giant Scale Cars
04-02-2005, 12:56 AM
Replies: 9
Views: 748
Posted By funshawstud

RE: Traveller/ Firehammer Assembly Photos

that is very impressive !
and will be very helpfull to the less expierianced 1/5 scalers out there.
bet you have some time invested in it to this point
Mike
Forum: RC Giant Scale Cars
03-29-2005, 01:10 PM
Replies: 9
Views: 713
Posted By funshawstud

RE: diffs AGAIN

different car same problem !
YES IT IS A FIRE HAMMER
I noticed some of the main drive gear screws had come loose so I tore it apart to fix. I felt the diff was very chunky while turning the...
Forum: RC Giant Scale Cars
03-26-2005, 06:16 AM
Replies: 11
Views: 1,405
Posted By funshawstud

RE: FireHammer/glitches?

I have to say that the radio is cheep.
BUT !
I can honestly say I have never had a problem with interference of any kind, lots of range to.
Dont know about any of the others but I dont think...
Forum: RC Giant Scale Cars
03-23-2005, 04:49 PM
Replies: 41
Views: 2,684
Posted By funshawstud

RE: Regular posters where are you?

we are all here still.
the fact FGUK is on moderation has led most of us not to bother.
I put up one post this week as it was a direct question to me otherwise I dont bother anymore.
Mike
Forum: RC Giant Scale Cars
03-23-2005, 09:09 AM
Replies: 20
Views: 1,637
Posted By funshawstud

RE: Firehammer or MT-5 - Worth it?

Garnet
I hand made the rims they are actually very easy
let me start by saying that you DO NOT have to change gearing I dont know why everyone is ???? the gear ratio has no affect on the rim...
Forum: RC Giant Scale Cars
03-22-2005, 05:12 PM
Replies: 20
Views: 1,637
Posted By funshawstud

RE: Firehammer or MT-5 - Worth it?

just buy a fire hammer and put beetle rims on it , dont go adapters you will end up spending double. If you have access to a machine shop make your own heavy duty rims then you can put whatever tires...
Forum: RC Giant Scale Cars
03-17-2005, 06:44 PM
Replies: 3
Views: 481
Posted By funshawstud

RE: Servo savers?

I would use at least 2 metal gear quarter scale servos with no dampers on the arms. ( rubber mount the servos though )
Put the dampers on the steering arm just like real trucks. I think this method...
Showing results 1 to 25 of 120
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.