RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: SlickZERO
Showing results 1 to 25 of 29
Search took 0.56 seconds.
05-14-2018, 02:24 PM
Replies: 4
Views: 1,934
Posted By SlickZERO

Thanks, I can see with all those steps there...

Thanks, I can see with all those steps there would be a lot of air under it and side slip?
05-14-2018, 02:22 PM
Replies: 0
Views: 590
Posted By SlickZERO

XT90-S Anti Spark Connector

XT90-S Anti Spark Connector. Has anyone tried these? Looks like a good idea. I use XT-60 on boats with 4 cell in parallel where each connector only carries 1/2 the load. I use 5.5 on others with a...
05-11-2018, 02:05 PM
Replies: 4
Views: 1,934
Posted By SlickZERO

Central RC Marine 44" Unlimited 44

From what I can tell from the pictures the Central RC Marine Unlimited 44 has an interesting bottom. It looks like it has multiple steps like a Cat and a large overhang at the rear. Does anyone have...
05-09-2018, 02:03 PM
Replies: 1
Views: 1,090
Posted By SlickZERO

Which Cat less likely to blow over?

I love Cats but I am always sending the rescue boat out. I have an Aquacraft Lucas Oil. If I run the batteries forward and keep the nose lower, manage throttle in chop, and slow down into the wind I...
05-05-2018, 11:13 AM
Replies: 297
Views: 46,779
Posted By SlickZERO

Are you still building the C-54?

Are you still building the C-54?
05-05-2018, 09:12 AM
Replies: 45
Views: 8,693
Posted By SlickZERO

Fuma, I like your paint job. What paint did you...

Fuma, I like your paint job. What paint did you use so it would be gasoline proof?
04-29-2018, 12:33 PM
Replies: 11
Views: 1,704
Posted By SlickZERO

Do you still need to choke the engine with the...

Do you still need to choke the engine with the electric starter? If so do you use a separate servo for the choke?
04-29-2018, 05:02 AM
Replies: 2
Views: 1,767
Posted By SlickZERO

Mean Machine 18 upgrade

I picked up a new Mean Machine 18. Pulled the motor and vacuum formed mount. I have a new (old model) OS Max 21 SE-M #12140. I was thinking it would make a fun conversion. I will reinforce the floor...
Forum: Kit Building
11-16-2016, 03:42 AM
Replies: 8
Views: 1,067
Posted By SlickZERO

Looks like Great Planes Plan Protector. I bought...

Looks like Great Planes Plan Protector. I bought a roll about 15 years ago and if worked perfect. Epoxy or CA would not stick. I got back into building and bought a new roll. I got the same result as...
Forum: Kit Building
11-16-2016, 03:26 AM
Replies: 20
Views: 3,857
Posted By SlickZERO

Canopy Glue for hinge points

It is Zap Adhesives Formula 560 Canopy Glue. It says, Specially formulated to bond Canopies and Plastic parts to wood, figerglass, paint, or MonoKote surfaces. Safely bonds vinyl, ABS, Butyrate, and...
Forum: Glow Engines
11-08-2015, 04:12 PM
Replies: 8
Views: 2,310
Posted By SlickZERO

On Board Glow Drivers. Discussion Q&A

I use all 4 stroke, mostly cowled in, and some inverted. I love the on board glow drivers. I have been using Sullivan for many years. When properly set up I just turn it on, hit the starter, and fly....
Replies: 10
Views: 2,904
Posted By SlickZERO

Gyro for ground handling

I have a couple WW1 tail draggers with fixed rear skid and narrow front wheel track. On a bumpy grass field it is hard to go straight for take off and landing. Ground looping is a pain and can cause...
09-03-2015, 06:31 AM
Replies: 55
Views: 7,995
Posted By SlickZERO

I have a new VS1 and a new K&B 3.5 I am going to...

I have a new VS1 and a new K&B 3.5 I am going to play with. I see this is an old thread but does the C/L of prop 3/16" above the bottom of the sponsons still hold true for a starting place? Thanks,...
Forum: Beginners
11-11-2014, 08:18 AM
Replies: 49
Views: 105,355
Posted By SlickZERO

The parts I wanted were cheaper at Tower and...

The parts I wanted were cheaper at Tower and other stores. Active Power Sports was the only one that showed them in stock. (which was a lie). That is how they got me, not that they were cheaper. They...
Forum: Beginners
11-06-2014, 01:44 PM
Replies: 49
Views: 105,355
Posted By SlickZERO

Do not order from them. 2 years ago everybody was...

Do not order from them. 2 years ago everybody was out of DLE 20 rods and cranks. I found them on Google. Ordered and after 2 weeks received the rod but still waiting on the crank. No response to...
08-15-2014, 03:41 PM
Replies: 12
Views: 5,653
Posted By SlickZERO

I bought one and it came with one XH board. I...

I bought one and it came with one XH board. I bought 3 more from Value Hobbies. Much cheaper. I had vol err and erratic voltage readings on individual cells. Would terminate charge. Fan would cycle...
05-22-2014, 02:47 PM
Replies: 12
Views: 5,653
Posted By SlickZERO

I just sent mine back. Had it about a month and...

I just sent mine back. Had it about a month and more intermittent problems showed up. Fan cycle on and off at 1 second interval. Port 4 quit charging after about 15 min with vol err. Restart and then...
Forum: Gas Engines
05-08-2013, 08:27 AM
Replies: 106
Views: 10,072
Posted By SlickZERO

RE: I am happy to announce to the gasser hobby

I am new to gas. Have flown glow for over 50 years. I just bought a CRRC 26i and a CRRC 55ii twin from S&W Giant Scale Models. I figure since Klotz spent the time and money to develope an oil...
Forum: Beginners
05-05-2013, 05:08 PM
Replies: 49
Views: 105,355
Posted By SlickZERO

RE: Is Active Powersports for real?

I paid with PayPal and has been over 4 months. I was lucky it wasn't more than just the rod but they will never get another dime out of me or any out of our 135 club members.
Forum: Gas Engines
05-05-2013, 02:46 AM
Replies: 106
Views: 10,072
Posted By SlickZERO

RE: I am happy to announce to the gasser hobby

Is anyone using the Klotz RC ModeLube?
Forum: Beginners
05-05-2013, 02:31 AM
Replies: 49
Views: 105,355
Posted By SlickZERO

RE: Is Active Powersports for real?

Tower and everyone else I know was out of the rod. So I Googled the part number and Active Powersports came up. They showed crank, rod, etc. everything in stock. It wasn't cheaper. They have a...
Forum: Beginners
05-04-2013, 06:06 AM
Replies: 49
Views: 105,355
Posted By SlickZERO

RE: Is Active Powersports for real?

I agree. I should have checked here before I sent them $135.00.
Forum: Gas Engines
05-04-2013, 03:05 AM
Replies: 42
Views: 4,395
Posted By SlickZERO

RE: twin vs single

I just received the Gold Wing 30% Sbach 242 50cc. Bought a CRRC 55ii twin and it fits in the cowl without cutting anything except 2 exhaust pipes and rear exit air hole.
Forum: Gas Engines
05-04-2013, 02:45 AM
Replies: 4
Views: 1,260
Posted By SlickZERO

RE: Any official CRRC engines distributor in the US ?

I just bought 2 CRRC engines from Wayne at S&W Giant Scale Models. He is great to deal with, super prices, and ships fast!
Forum: Beginners
05-04-2013, 01:38 AM
Replies: 49
Views: 105,355
Posted By SlickZERO

RE: Is Active Powersports for real?

Can't believe they are still in business. They got me. If you notice they show everything in stock. I ordered several parts for a DLE 20 from them because everybody else was out of the rod. They...
Showing results 1 to 25 of 29
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.