RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: Hellcat1st
Showing results 1 to 25 of 62
Search took 0.57 seconds.
Forum: Electric Training
05-11-2006, 10:40 PM
Replies: 3
Views: 554
Posted By Hellcat1st

RE: UNIDENTIFIED BRUSHLESS 40O MOTOR HELP PLEASE!

how about a picture also are there any markings or numbers to go by?
Forum: Brushed/Brushless motors, speed controls, gear drives
04-20-2006, 10:42 PM
Replies: 3
Views: 756
Posted By Hellcat1st

RE: small ESC, motors and servos

The Only rule I have about ESC is to check what the motor manufactor rates the motor at Ie if it is rated at 15 amps I go with a 20-25 amp esc The 8 turn I blieve has to due with the nimber of...
Forum: Electric General Discussion
04-20-2006, 12:30 AM
Replies: 2
Views: 458
Posted By Hellcat1st

RE: Question from newb...

Use the reciever that is set up for your radio (there are some recievers that are made for park flyers thay are lighter and som have reduced ranges) Your esc plugs into your throttle port on...
Forum: Beginners
04-20-2006, 12:05 AM
Replies: 7
Views: 843
Posted By Hellcat1st

RE: Fuelproofing the Firewall

I paint my fire walls with the same color dope as the covering as for the edges of the film i use CA to hold them in place
Forum: Aerodynamics
04-19-2006, 12:30 AM
Replies: 9
Views: 1,100
Posted By Hellcat1st

RE: a little more advanced question about props

For what it is worth With an lt-40 an evolution 46 engine when i switched from master air screw 12X4 prop to apc 12.25 X 3.75 wide prop I gained 400 rpm And the plane climbs unbelivably better the...
Forum: Electric Pattern Aircraft
04-18-2006, 10:29 PM
Replies: 27
Views: 9,704
Posted By Hellcat1st

RE: Gws Formosa

With the GWS 350 C motor combo And a 11x4.7 prop on a 2 cell 1500 mha lipo My formasa flew very well it would not hover but it would easily loop from level flight Try it for a while Run the motor...
Forum: Electric Training
04-18-2006, 10:21 PM
Replies: 4
Views: 638
Posted By Hellcat1st

RE: dirt slinging r/cer looking to the sky

Helis are hard the only small inexspensive one I reccomend it the e-flight Blade CX coaxial rotor set up.
With cars and planes it is the same thing the better the radio the more costly it is If...
Forum: Brushed/Brushless motors, speed controls, gear drives
04-18-2006, 10:14 PM
Replies: 24
Views: 2,516
Posted By Hellcat1st

RE: Brushless motors.. i dont get it

Whoops sorry on the link here it goes again

http://www.flyingmodels.org/index_en.htm
Forum: Brushed/Brushless motors, speed controls, gear drives
04-18-2006, 10:13 PM
Replies: 24
Views: 2,516
Posted By Hellcat1st

RE: Brushless motors.. i dont get it

Here is the only compiled list of motor specks and batteries i have found may help Only problem is they did it with nimh batteries but should give you a ball park. Axi does pretty good at giving you...
Forum: Glow to Electric Conversions
04-13-2006, 12:09 PM
Replies: 3
Views: 706
Posted By Hellcat1st

RE: LT 40 CHEAP E

Jim3d2004 Sorry plane hasnt flown yet I am waiting for my lipos to get here the nihm packs i used for testing are only 1500 mha run time is only about 5 minunets If they get here maiden flight is...
Forum: E-Flight Power Sources
04-11-2006, 11:37 PM
Replies: 13
Views: 23,711
Posted By Hellcat1st

RE: Programming an ESC for Lipos

Not the exact same controler but try this Also an e-bay esc

TOWERPRO CO.LTD
BMC SERIES BRUSHLESS MOTOR CONTROLLER
SETUP MENU (only for 40A, 60A, 100A, 140A)
Type Current Fe t BEC Timing...
Forum: Electric General Discussion
04-11-2006, 10:58 AM
Replies: 3
Views: 505
Posted By Hellcat1st

RE: help with scratch projects for my setup

Sorry I don't have the links bookmarked but run a search for "profili" this is out of Italy or "compufoil" they both have free demo versions some featues are dissabled but they are realitivly...
Forum: Electric Training
04-11-2006, 10:51 AM
Replies: 10
Views: 1,163
Posted By Hellcat1st

RE: Slow Stick replacement ideas needed...

I am not sure how that would work Try zip tying on som lead ballast to bottom of frame start with about 1 once go up from there local auto parts or tire shop should beale to get you the "MAG wheel...
Forum: Electric Training
04-10-2006, 11:28 PM
Replies: 10
Views: 1,163
Posted By Hellcat1st

RE: Slow Stick replacement ideas needed...

GWS E-starter Try to get one with the 400 size motor a little more weight in your instance should help
Forum: Electric General Discussion
04-10-2006, 10:03 AM
Replies: 3
Views: 505
Posted By Hellcat1st

RE: help with scratch projects for my setup

OK here is the link to some free software so you can veiw the plans
http://www.freebyte.com/cad/cad.htm

Here is a couple of sites were you can find free planes You will be able to scale down...
Forum: Electric Training
04-09-2006, 11:12 AM
Replies: 3
Views: 651
Posted By Hellcat1st

RE: First Plane

Anything that flies is great. But if you havent flown before it may be difficult to learn to fly a 3 channel minimum 4 channel is best. see if you can find an exsperianced piolet to hlp you out. ...
Forum: Electric Training
04-09-2006, 11:05 AM
Replies: 21
Views: 1,754
Posted By Hellcat1st

RE: Firebird Freedom looping

If you move to the lower holes it will make the plane more "touchy" but you are still going to need room to get up to speed to loop the plane are you using the upgrade battery more power will be...
Forum: Electric General Discussion
04-06-2006, 07:09 PM
Replies: 2
Views: 453
Posted By Hellcat1st

RE: Cool - Lots of Free Plans for Electrics!

Thanks for the Info Here is Another 1 for you to check out they have both electric and glow plans
http://plans.rcmodell.hu/index.html

Thanks again Wish I could build them as fast As I crash...
Forum: ARF or RTF
04-06-2006, 06:59 PM
Replies: 4
Views: 1,318
Posted By Hellcat1st

RE: nitro park flyer?

If you want a war bird check out the Me=109 By global http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXK421&P=0 also any 15-25 size afr can be converted to electric pretty easily Brusshless and...
Forum: Brushed/Brushless motors, speed controls, gear drives
04-06-2006, 02:47 PM
Replies: 2
Views: 545
Posted By Hellcat1st

RE: HOT ESC

Have you hooked it up to a meter to see haw many amps you are drawing? sounds like you are exceding the lilit of your ESC
Forum: Seaplanes
04-06-2006, 02:41 PM
Replies: 13
Views: 1,010
Posted By Hellcat1st

RE: Need your input!!

Useing flaps for take off can be difficult generally for take off your flaps should be set to about 1/2 of what they are for landing. With flaps deployed they dent do cause the plane to nose down...
Forum: ARF or RTF
04-06-2006, 02:31 PM
Replies: 1
Views: 531
Posted By Hellcat1st

RE: GSP Super Chip engine mount question???

Pitts and slim line both make "pitts" stilye mufflers I used 1 on my Super tiger 90 it works well But I Soldered caps on the ends of mine and drilled the holes smaller to increase back pressure ...
Forum: Beginners
04-05-2006, 10:19 PM
Replies: 7
Views: 891
Posted By Hellcat1st

RE: Sig Kadet

It seams like a great deal the only down side to the kit version of the Sig Senior is no ailorons Bud this is a semi easy fix I have A senior and 3 lt-40s they fly great and after you learn to...
Forum: ARF or RTF
04-04-2006, 09:40 PM
Replies: 2
Views: 731
Posted By Hellcat1st

RE: Phoenix dolphin Tower .46 Combo

You Are going to get a lot of different responses to this I don't claim to be an expert but I have had good results with this method. I strictly use Power master 15% heli Mix It has a higher Oil...
Forum: ARF or RTF
04-04-2006, 09:25 PM
Replies: 348
Views: 92,161
Posted By Hellcat1st

RE: How Many Airplanes Do You Have In Your Hangar?

I got:
3 Sig LT-40s 2 flying i I am tricking out And 1 is stricktly a float plane
1 Sig senior stock
I Sig four star 40 Custom tail w increased controll surfaces
i china models F6F Hellcat
...
Showing results 1 to 25 of 62
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.