RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Moby58
Showing results 1 to 19 of 19
Search took 0.56 seconds.
Forum: Electric RC Helis
10-20-2005, 10:04 AM
Replies: 1
Views: 494
Posted By Moby58

RE: want to upgrade walkera rx. which to pick?

The GWS Rx will work, but ONLY if you also change your transmitter. I use 2 of them with my JR X388 transmitter. And that is the same if you want to use any receiver.

The Walkera Tx and Rx are...
Forum: Electric RC Helis
10-20-2005, 09:58 AM
Replies: 1
Views: 442
Posted By Moby58

RE: Walkera 35

Hi,

I have a Walkera Dragonfly #35, and just recently bought a zoom/shogun 400.

OK, on the dragonfly, I bought the Walkera 3300Kv brushless motor with the Walkera 30A ESC. You can usually...
Forum: Electric RC Helis
10-13-2005, 03:46 AM
Replies: 27
Views: 9,432
Posted By Moby58

RE: brushless motor problem

I have a Walkera #35, and bought the Walkera brushless motor and 30A ESC combo. In my heli, with cheap 1300 mAh LiPo batteries, I get about 12 minutes hover time.

I havent seen any posting on...
Forum: Electric RC Helis
10-08-2005, 08:32 PM
Replies: 27
Views: 9,432
Posted By Moby58

RE: brushless motor problem

Just had a look at the #36

I have a #35 (shaft drive) and the motor drives the tail rotor. No motor = no tail rotor.

But I see the #36 uses to main gears (like the T-Tex), so the tail rotor...
Forum: Electric RC Helis
10-06-2005, 06:45 PM
Replies: 6
Views: 657
Posted By Moby58

RE: Where do you hook the Brushless ESC on the Walkera #36 Rx

OK, you unplug the battery and motor wires from the battery and motor, and just leave them.

The battery then plugs into the ESC, and the ESC plugs into the receiver.

That is how the...
Forum: Electric RC Helis
10-05-2005, 10:07 PM
Replies: 6
Views: 657
Posted By Moby58

RE: Where do you hook the Brushless ESC on the Walkera #36 Rx

Yes,

Channel 3 should have nothing it it. That is where you connect.

Normally there is nothing in channel 3 because the receiver also has the speed controller built in.
Forum: Electric RC Helis
10-05-2005, 10:04 PM
Replies: 4
Views: 578
Posted By Moby58

RE: All digital servos on Zoom 400 chopper??

Hi,

Yep, brother has all digital servos in his 40% plane models, and when ya have about 15 of them (large ones), they draw a bit of power.

However, interested in how 4 mini ones will go.
...
Forum: Electric RC Helis
10-05-2005, 07:31 PM
Replies: 4
Views: 578
Posted By Moby58

All digital servos on Zoom 400 chopper??

Hi guys,

Currently have a Walkera#35 chopper, with brushless motor and ESC, and using Futaba GY-401 gyro and LiPo batteries.

Have ordered this belt-drive Zoom 400 , and will be transfering...
Forum: Electric RC Helis
09-28-2005, 07:43 PM
Replies: 27
Views: 9,432
Posted By Moby58

RE: brushless motor problem

Hi Biggy Boy,

And you are definetly talking about the Walkera 30A ESC (WK-WST-30A)?? As I have one of these and there is no tones from it....
Forum: Walkera Helis - Dragonfly, etc..
09-28-2005, 09:44 AM
Replies: 1,392
Views: 258,576
Posted By Moby58

RE: Walkera DragonFly #35 CCPM Electric RC Helicopter Reviews

Howdy, good ta see it has arrived

1) They adjust the offset from throttle, and amount of travel. However, iirc, you need to flick one of the switches (marked I think) on back of Tx to make them...
Forum: Electric RC Helis
09-21-2005, 08:37 PM
Replies: 10
Views: 1,538
Posted By Moby58

RE: JR 347 and Hitec Electron 6 poblem

Ok,

The main lead of the gyro is plugged into the rudder channel, and the gain control lead is pligged into the gear channel (usually 6).

Then, going into radio setup, you adjust the travel...
Forum: Walkera Helis - Dragonfly, etc..
09-09-2005, 08:56 PM
Replies: 1,392
Views: 258,576
Posted By Moby58

RE: Walkera DragonFly #35 CCPM Electric RC Helicopter Reviews

Generally, you should bring the power slowly up until almost lift off. The heli should be light on the skids (and should be able to rotate it with rudder input).

Then you should put a short...
Forum: Electric RC Helis
09-08-2005, 03:22 AM
Replies: 10
Views: 1,538
Posted By Moby58

RE: JR 347 and Hitec Electron 6 poblem

Hi,

From the days when I did more RC, I was using Futaba, Hitec, Sanwa (Airtronics) and JR Rx's with my JR X-347 and X-388

The gear must have it's own manufacture crystal.

That is the...
Forum: Electric RC Helis
09-07-2005, 07:48 PM
Replies: 17
Views: 1,822
Posted By Moby58

RE: Walkera 35 problems

OK,

Have heard mixed reports (thru forums) on the Tower Pro, but are generally better than the Walkera ones.

The Hitec HS-55 are supposed to be OK, but from what I have seen, I think they...
Forum: Electric RC Helis
09-07-2005, 08:17 AM
Replies: 17
Views: 1,822
Posted By Moby58

RE: Walkera 35 problems

Hi,

Sympathise with your problem.

However, having been involved with a dispute with something I bought, and had to return, after lodging complaint with eBay, eBay do not require the seller...
Forum: Electric RC Helis
09-07-2005, 08:12 AM
Replies: 17
Views: 1,822
Posted By Moby58

RE: Walkera 35 problems

Hi Foreverknight,

First off, I think you have to be a bit careful to what you label a 'death trap' without actually doing a bit of checking of other things first. You have no categoric proof...
Forum: Electric RC Helis
09-02-2005, 07:14 PM
Replies: 2
Views: 367
Posted By Moby58

Dragonfly #35. How do you keep canopy on??

Hi Guys,

OK, whats the secret to securing the canopy on the Dragonfly #35??

And I suspect a lot of other micro choppers dont have great methods to keep it secure either...
Forum: Electric RC Helis
09-02-2005, 06:11 AM
Replies: 2
Views: 670
Posted By Moby58

RE: Adjusting Futaba GY-401 sensitivity??

Ahh,

Thanks VERY much for that... Instruction are not that clear til after I read your post. Can now adjust the sensitivity :-)
Forum: Electric RC Helis
09-01-2005, 07:50 PM
Replies: 2
Views: 670
Posted By Moby58

Adjusting Futaba GY-401 sensitivity??

Hi Guys, I have a dragonfly/Walkera #35 heli.

I have add the Walkera brushless motor, and ESC, with 1300 LiPo 3-cell battery, and also changed the receiver to a GWS 6ch micro receiver, and using...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.