RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 6
1
2
3
Last »
Search: Posts Made By: iliveonlytocrash
Showing results 1 to 25 of 140
Search took 0.56 seconds.
Forum: Gas Engines
07-19-2023, 12:13 PM
Replies: 1
Views: 823
Posted By iliveonlytocrash

Best battery for RCGF stinger 15RE with high voltage ignition

Need some help to decide which battery (and Servos) to use for the high voltage ignition used on the RCGF stinger engines. Label says 7.4v to 14v.

Should I use a 6 cell NiMH, or 2 cell LiFe, or...
Forum: Gas Engines
08-12-2012, 03:38 PM
Replies: 39
Views: 4,476
Posted By iliveonlytocrash

RE: What Airplanes are you Installing a Mintor22cc gas engine in?

Aeroworks Pro X260. I have over 100 flights on it. Excellent plane and engine combination. The Mintor is the best overall of the 4 different brands of engines I have in this size range.
Forum: Gas Engines
07-18-2012, 04:38 PM
Replies: 165
Views: 26,591
Posted By iliveonlytocrash

RE: mintor engines

79 degree temperature
700 feet ASL
60% humidity
16 x 8 APC Prop

8550 RPM before cleaning all the grass stains off the prop
8350 RPM after cleaning the grass stains off

carb is tuned...
Forum: Gas Engines
07-17-2012, 07:19 PM
Replies: 165
Views: 26,591
Posted By iliveonlytocrash

RE: mintor engines

You will be fine with the separate 4.8 volt battery. That's what I used on my test stand. On my planes, I normally run a one 5 cell battery (for both receiver and ignition) and use 2 dropping...
Forum: Gas Engines
07-16-2012, 07:14 PM
Replies: 165
Views: 26,591
Posted By iliveonlytocrash

RE: mintor engines

Are you going to use a single battery to power both the receiver and ignition unit, or will you use a separate battery for the ignition?
Forum: Gas Engines
07-15-2012, 07:18 PM
Replies: 165
Views: 26,591
Posted By iliveonlytocrash

RE: mintor engines

Just wondering if you have flown 260X/Mintor yet and if so, how well do you like it? I have about 30 flights on mine and so far, its the best performing gas engine in this size range that I've seen...
Forum: Gas Engines
09-01-2011, 03:50 PM
Replies: 6,892
Views: 1,136,522
Posted By iliveonlytocrash

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

Looking for some suggestions.

Have a DLE 20 mounted on a ProX260 profile from Valley View. The engine is mounted with the cylinder in the 3:00 position as viewed from the cockpit. The engine...
Forum: 3D Flying!
08-30-2011, 08:03 AM
Replies: 227
Views: 40,377
Posted By iliveonlytocrash

RE: Goose's Aeroworks ProX260 build thread

qspilotcmh,

I'm having the same CG problem with my plane with the DLE 20 (about 8 oz added to the nose). When you get you engine placement figured out, could you post your results.

Thanks
Forum: 3D Flying!
05-21-2011, 05:53 AM
Replies: 25
Views: 2,821
Posted By iliveonlytocrash

RE: How Many Times Have You Crashed?

My name says it all!!! :D
Forum: Gas Engines
03-31-2011, 04:45 AM
Replies: 7
Views: 1,174
Posted By iliveonlytocrash

RE: Is this engine too heavy for a telemaster?

I've been running a Zenoah G20 for a few years in my Sr Telemaster. Its a perfect combination. I mounted the elevator and rudder servos in the tail.
Forum: Gas Engines
03-02-2011, 06:10 PM
Replies: 6,892
Views: 1,136,522
Posted By iliveonlytocrash

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

raubold,

Thanks for posting the pictures. I like the looks of the sideways mounted engine. Its a lot cleaner looking than mine, especially with that cowl. Great job with the install on the...
Forum: Gas Engines
02-23-2011, 07:34 PM
Replies: 6,892
Views: 1,136,522
Posted By iliveonlytocrash

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

Still having trouble.
Forum: Gas Engines
02-23-2011, 07:31 PM
Replies: 6,892
Views: 1,136,522
Posted By iliveonlytocrash

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

I'm having trouble uploading more than 1 picture at a time.
Forum: Gas Engines
02-23-2011, 07:29 PM
Replies: 6,892
Views: 1,136,522
Posted By iliveonlytocrash

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

I am also building a delta vortex with a DLE 20cc gas engine. I'm building it in a tail dragger configuration with graphtech landing gear and dual sullivan tailwheels on the rudders. I pined the...
Forum: Kit Building
01-23-2011, 08:11 PM
Replies: 49
Views: 7,921
Posted By iliveonlytocrash

RE: Delta Vortex build

Thanks for the picx of the DLE 20. I looked at the BTE website and found where Bruce mentions that some builders have moved the servos (throttle and nose wheel) to the rear and then moved the...
Forum: Kit Building
01-23-2011, 05:20 AM
Replies: 49
Views: 7,921
Posted By iliveonlytocrash

RE: Delta Vortex build

I am putting a DLE 20cc gas engine in mine. I hope it isn't too heavy. I was considering splitting the stationary horizontal fin (between the rudders) and hinging it to the trailing edge, and...
Forum: Kit Building
01-20-2011, 08:08 PM
Replies: 49
Views: 7,921
Posted By iliveonlytocrash

RE: Delta Vortex build

I am also in the process of building the delta vortex. I would be interested in any pictures and info you have time to post. What engine are you putting in it?
Forum: Gas Engines
12-21-2010, 08:30 PM
Replies: 10
Views: 1,270
Posted By iliveonlytocrash

RE: 17cc gas in a Sr. Telemaster

I have a Zenoah G20 in mine and it is a great combination. It does not quite have unlimited vertical.
Forum: Gas Engines
11-28-2010, 11:39 PM
Replies: 6,892
Views: 1,136,522
Posted By iliveonlytocrash

RE: NEW DLE 20cc Gasser! (Data & Links 1st Post)

What type of battery are you using?
Forum: Gas Engines
11-25-2010, 10:27 PM
Replies: 35
Views: 6,338
Posted By iliveonlytocrash

RE: Gas Can

I go buy a gas can of my choice. Then take it to the lawn mower shop and buy a cap that fits it. Then drill a hole in the top the exact size to take a gas compatible stopper assembly that we...
Forum: Gas Engines
11-01-2010, 09:05 PM
Replies: 13
Views: 1,546
Posted By iliveonlytocrash

RE: Which of the available manual gas pumps is the best.

I've had by far the most reliability and the longest life with the MPI.
Forum: Gas Engines
10-25-2010, 11:38 AM
Replies: 127
Views: 13,739
Posted By iliveonlytocrash

RE: STOP with the oil ratio threads, please.

Perhaps it would be best for someone to make a sticky for newbies on oil issues like the one Bob Pastorello made for general info on gas engines. Maybe even just incorporate it in with Bob's sticky?
Forum: Gas Engines
08-20-2010, 08:35 AM
Replies: 27
Views: 3,178
Posted By iliveonlytocrash

RE: Black goo

Try ether (diesel starting fluid). It will clean anything and dry almost instantly. For normal clean up, I've found rubbing alcohol (90%) in a spray bottle to work the best.
Forum: Gas Engines
08-13-2010, 03:43 PM
Replies: 20
Views: 1,783
Posted By iliveonlytocrash

RE: battery for cdi unit?

http://www.batteriesamerica.com/
Forum: Gas Engines
08-04-2010, 01:48 PM
Replies: 13
Views: 1,891
Posted By iliveonlytocrash

RE: using a single lipo with RCEXL igniton

The battery eliminator I designed drops it down to 4.3 volts. 6 volts is too much.
Showing results 1 to 25 of 140
 
Page 1 of 6
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.